Top 20
Nakajima AE-710 Typewriter Questions & Answers
My typewriter beeps after turning on
The typewriter didn't get to its home position...Make sure the cover is down..,nothing blocking the carriage from moving..check withe the power off...and nothing cought in the printwheel area.
Clear the underscore
Go to nadist.com you will find a manual there. It's just a matter of using the code key and a top row key.
DickyO
How to change margins
Go to the margin, press but don't hold the mar rel key, space or backspace to the desired location, press L. or R. margin key dependingon which one you are setting.DickyO
The printwheel has been removed, how do I reinsert it?
The printwheel just drops into the slot you took it out of with the letters toward the platen and push the P/W release lever to the rear.If you want a downloadable manual go to NADIST.COM click on current models.DickyO
We type on address labels,
Labels often have a glossy surface that correctable ribbons will not print well on.. Try these, move the impression control on the left to the largest dot, set up to print in bold, get a fresh ribbon not just another one off your shel.
DickyO
Have a Nakajima AE-710 typewriter
I googled the part on the internet and saw a number of them available. I only looked at the first few results and found them priced from around $12 to $30 . Amazon had the widest price range. If you google "Nakajima Platen Knob" a number of results turn up. The Nakajima's were made by Swintec (or vice-versa) so the Swintec platen knobs are interchangable.
Hope this helps
What is the correct way to put the pinwheel in
Remove the ribbon, pull on the black lever right of the hammer, drop the P/W into the opening, push the lever back..
Go to NADIST.COM, click on current models you will find a manual there.
DickyO
Is there an adjustment for
You may have debris on the paper tray. On the L. end of the platen is a metal latch, push it down and remove the platen .
DickyO
Removed old ribbon cartridge. Unable to install
First thing remove the ribbon turn the hand feed knob and see if the ribbonmoves if not you have a bad ribbon. The ribbon has 2 little feet thar hook on the ribbon deck and then it snaps down and latches into place. Go to NADIST.COM, Click on current models you will find a manual there.
DickyO
Not finding what you are looking for?