20 Most Recent
Nakajima AE-710 Typewriter - Page 6 Questions & Answers
Operating manual
Contact Nakajima at 1-800-809-7138 they are very helpful.
DickyO
How do you insert correction tape?
The slots for correction tape is at the ribbon carriage left & right. Install it by first attach the supply side (full tape) at the left and make sure the rough surface of the tape face toward the platen and attach take off side at the right side.
Typewriter just beeps
very common problem, The print wheel homing sensore weirs broke off. you need to take off the ribbon deck. pull weirs from the white plastic sleeve that runs from carrier to main board. fined 3 weirs grouped together ( red, black,green) 1 or more of them are cracked in side the casing or have broke in 1/2. need to resolder them together little tough to do the 1st time. a bunch of sen sores came out with to hard of a weir making them brake premacherly
I am trying to type
there is a slide switch on the L.H. side of the key board that reads 10,12,15, PS
the switch needs to match the print wheel stile you have in your typewriter. most typ's have 10 or 12.
PS stands for proportional spacing a takes a spicule print wheel
AE-710
First see if the ribbon is spacing a full space for each letter pressed if not you may be in the over strike ribbon mode, to get out of the mode press code and comma, period or slash i'm not sure which one So try them all.
If that dosen't help check to be sure the correction tape is not getting in the way, remove the corr. tape and try it.
Next remove the ribbon and release the hammer as if you were changing the P/W and see if the plunger in the solenoid is free, if not try a drop or two of WD40 on it.
DickyO
Margin Release
Try holding down on the MR (margin release) key and turn on. Machine will print a few lines with all the letters. Turn off and then on and try. Also make sure someone has not switched the key tops for left marging and right margin, I have seen this "joke" played on people. Can you set either margins?
AE-560
Contact Nakajima at 1-800-809-7138 they are very helpful.
DickyO
Help
Alittle more info would be helpful. First be sure paper space is not in (PS).
Dickyo
Nakajima ae 710
you have to press code + either , or . at the same time, that function is for multistrike ribbon where the ribbon feed move slower.
Not finding what you are looking for?