20 Most Recent
Gold Medal 2003 Whiz Bang Popcorn Maker - Page 2 Questions & Answers
Trying to find kettle wiring drawing 3255
To order a manual from the factory the part# is 67834. Depending on how old this is , those kettles and or similar design had a issue with the nut comming loose that holds down the thermostat thight to the bottom of the pan. The loose nut would then bounce around in there until it touches a elect.connection and ground at the same time. It will short circuit the kettle and end up welding itself in place . so when you turn the kettle on it trips the circuit rite away. you have to dissasemble it and remove it . there is a new locking type nut avalible to replace it.
Popcorn burns
If the corn/ oil ratio is correct , check the thermostat operation . It is burning because it's in there too long from lack of heat to make it pop.
Gold Metal Popcorn Machine 1618 ETS
That is a 16 oz popper with big eye electonics, With a Target Store Neon sign. This model was only sold to Target Corp.
There is no question here.
Is there a reset switch after you change filters
If you are speaking about poppers with a Popclean feature, there is not a reset switch. There is a sensor that looks for air movement volume, when the air "vacuum" is weak it sets off the change filter light.
Why is my gold medal popcorn model # 2552 machine not heating to pop popcorn anymore?
A kettle not heating is either a switch, kettle wires, thermostat, or kettle heater.
Check that the kettle is plugged in tight, notice if the switch lights up when switched, then contact your local gold medal dealer for repairs. It is always cheaper to repair a gold medal kettle than replace.
http://www.gmpopcorn.com/domestic-dealers.cfm
Agitator has come out of popcorn machine
if you have a gold medal popper, there is a weight on the shaft the sits over the middle hump of the stir wire. you must take the lid asembly off of the kettle to get the stir wire back in.
they do not fall out without some thing else wrong, check if the shaft is broken under neath the weight.
11/23/2013 12:50:50 AM •
Gold Medal...
•
Answered
on Nov 23, 2013
Agitator will not slip through cross bar after all
The bushings in Gold Medal Cross bars should not be removed. Could you mean the Set collars?I have had kettles where I have had to hammer the agitator out of the crossbar pretty heavily. Carbon from the oil can get up in there and lock it into place. Place the crossbar in a bench vice to support the sides close to the center, but not tightened. Be sure to use a piece of wood(you will destroy the scrap wood in the process) between the hammer and the agitator shaft to prevent damaging the agitator shaft.
Oil to popcorn ratio for model 2085?
All popcorn machines use a 3or4:1 corn to oil ratio. More specifically the model 2085 is a 6 oz popper.6oz. popcorn (3/4 cup)1.6 - 2oz oil (1/4 cup)1-2 tsp popcorn salt
Not finding what you are looking for?
