20 Most Recent Kodak EasyShare M1033 Digital Camera Tripod Questions & Answers


Replace it - you have successfully damaged it beyond economic repair.

Kodak EasyShare... • Answered on Jun 26, 2017


check you power on switch, mine had the same problems as yours, kodak didnt help much but i checked the power switch and it was jammed a little so unjammed it an lo and behold fixed it saved myslef a lot of time.

Kodak EasyShare... • Answered on Sep 10, 2011


Your problem is either likely the lens or a sensor. However kodak does not sell just the lens and out of warranty repair is 70.00. Screw them guys! Ill send it some wheres else to fix. Its less than a year old, I lost the recipt and can't read a few numbers on the sticker for the serial number. So basically he tried to sell me a new camera for 15% off, when the camera cost more now then it did when i got at Walmart!

Kodak EasyShare... • Answered on Apr 11, 2010


Ii understand your problem description as the camera turns off immidietly after having shown the date and time.

Here are the steps:
1. Make sure you will install a new or fully charged battery/batteries into your camera.
2. Clean the battery contacts.
a. Remove the battery/batteries and the memory card from your camera, then wipe the battery contacts with a soft, clean cloth.
b. Reinstall the battery/batteries into your camera
3. Without the memory card,turn on your camera.
4. Pls test with an alt. batt.
If you do not have access to a dif. battery.
Pls. take the batt out of the camera. Insert the charger into the unit from the main socket and turn the camera on. If the camera works you will need to replace the batt. If not you will need to order a No power repair.

Contact KODAK:
http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=14563&pq-locale=en_US&_requestid=3490

Kodak EasyShare... • Answered on Nov 25, 2009


If your using the battery which is included on the box the KLIC-7004 try to clean the 3 metal contacts of your battery using a clean dry cloth. hen charged the battery using AC adaptor or USB cable., Now if this not work, Try to turn On the camera using the AC adaptor if you experienced same problem it means the your camera is defective, But if you can turn On the camera using AC adaptor It means the battery is the cause of the problem

You may call tech support toll free 1 800 235 6325 ext 12

Kodak EasyShare... • Answered on Nov 13, 2009


I fixed it, I hit it softly a couple of times lol.

Kodak EasyShare... • Answered on May 01, 2009


your lense isnt extending because u need to charge your battery i gaurentee as soon as u let it charge it will extend once again

Kodak EasyShare... • Answered on Feb 06, 2009


To the best of my knowledge all 35mm cameras load identically, apart from a few automatic models that claimed to be self loading. A new film cassette has a tongue of film protruding. Once the cassette has been loaded into the recess on the left and the rewind crank pushed down and engaged with the film spool, a couple of inches of film is pulled from the cassette and the tongue poked through the slot in the takeup spool - it might be necessary to use the film advance until the slot is visible. With about a half-inch of film pushed through the slot, slowly advance the film until the slackness is gone while fully engaging the sprocket holes at the edges of the film on the teeth of the sprockets. Advance the film a little more to check it is properly engaged and once you are satisfied close the camera back firmly making certain the catch is engaged and it won't spring open again. Once closed, advance the film until it stops which signals the shutter is set and is ready to take a photograph, however the first and perhaps the second frame has been contaminated with light and so press the shutter release, advance and press again and the third advance is where the photographs begin. If there is a frame counter it is best to be guided by this. Cameras that have a manual advance usually have a manual return crank that will be seen to rotate as the film is advanced. When all the frames have been used the film will be felt to come to the end. At this point the clutch button must be pressed to disengage the wind-on mechanism and the film wound back into the cassette using the crank on the left.

Kodak... • Answered on Sep 30, 2020


Again, most kind of you to pass on this information. Was there any particular reason behind your doing so ?

Kodak... • Answered on Aug 24, 2017


If you are disabled, and use a walking frame, you should be able to get assistance from the Social Services department of your local council

Kodak... • Answered on Aug 17, 2017

Not finding what you are looking for?
Kodak EasyShare M1033 Digital Camera  Tripod Logo

16 questions posted

Ask a Question

Usually answered in minutes!

Top Kodak Photography Experts

Davit Mamyan
Davit Mamyan

Level 3 Expert

552 Answers

Tom Chichester

Level 3 Expert

61759 Answers

Relax
Relax

Level 3 Expert

34002 Answers

Are you a Kodak Photography Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kodak Photography

  • Kodak Photography

Most Popular Question

kodak m1033 camera screen totally

  • Photography
Loading...