Goldstar DH2510A Dehumidifier - Page 9 - Answered Questions & Fixed issues

If you are referring to your humidity setting for an average basement in summer heat between 55%-60% finding 60% to be more ideal.

I had the exact same problem with this exact dehumidifier the bottom of the drawer was cracked iv been trying to find a new drawer

https://www.jondon.com/media/pdf/manuals/DP-F515_manual.pdf ER3 CONTACT SERVICE CENTER Unit in defrost too long. Check defrost sensor cable for proper connection. If error persists, sensor assembly may require replacement. Contact service.

https://www.manualshelf.com/manual/keystone/kstad70c/warranty-english.html See phone number in web link above. Beware FIXYA spam and fraudulent phone numbers often posted for many years here.

1. Check that the filter in the unit is clean.
2. Check that the room temperature is above 41 degrees.
3. Check that the humidity isn't set too low, recommended humidity is 45~50%
4. Make sure that the unit has plenty of space all around to allow for sufficient air circulation.

https://www.justanswer.com/hvac/crtbw-fix-dehumidifier-e9-error-code-won-t-work.html https://support.edgestar.com/hc/en-us/articles/201000315-My-dehumidifier-is-displaying-an-error-code-What-does-it-mean-

Load to big for breaker , Faulty breaker , Short circuit on dehumidifier .

Your humidistat is stuck in the "on" position. Probably need to replace it.

Yes, these types of dehumidifiers use a compressor that warms the air to remove the water.

you maybe able to find that here www.discountbargainprices.net

A dehumidifier works in a similar way to an air conditioner, cooling the air that passes through it so water vapour will condense and collect into a container. If the fans are working and air is circulating through the unit but no water is being collected the internal refrigeration system probably has a fault...

Could be the humidity is low enough it isn't turning on. Try to lower the humidity setting to see if it will turn on. Once the humidity gets down to about 50-55%, dehumidifiers don't work very well at pulling out the humidity..

Pull out bucket and see if the hose it attached to the drain connector/ sometimes it pulls away:

Code EH code indicates that the humidity sensor is malfunctioning. Needs to be replaced.

The manual says to contact customer service 866-827-4985. I believe the code refers to a sensor error.

what happened to the manual?

If it is blowing: room air = no cooling hot air = unit is running cool air = unit is trying to empty sounds like it is NOT hot air

At 21°C u must have an air flow blockage. It should not freeze up there.

operation at or below 41°F

if it is blowing: room air = no cooling hot air = unit is running cool air = unit is trying to empty sounds like it is NOT hot air