20 Most Recent
Emerson BAR900 MP3 Player Questions & Answers
When i plug in the
when i plug in the device it says that the drivers could not be found is there any way i can get the drivers
My mp3 player keeps on saying waiting for music
Following Instruction check:
1. Check Your MP3 player memory. If it's full- then it will show this message.
2. Remove your some unwanted music from your MP3 player.
3. Check your MP3 player Memory Capacity in your Emerson Manual.
USB Port Not Recognized
Here Two Reason for USB Port Not Recognized:
1. Check you USB cable properly connected to the you computer, If cable break or not connected properly, It will show your cable not recognized.
2. If again these problem shows. go to,
My Computer - right click - Properties - Hardware - Device Manager - and Unistall you USB drivers - then again scan new hardware.
Wont play song
the first thing you should do is backup and remove all songs through your usb software interface. be sure to have windows 10 installed. also, be sure that you're loading only .mp3 or .wma files to the machine.
This is a link to the manual. you should follow the guidelines laid out in it for the device.
I HAVE AN EMERSON MP3
I have an Emerson 2gb MP3 player model EMP 312-2, not sure if this info is for you or not. Make sure you are in the MUSIC MODE, when you use the menu button to go from music mode, voice mode, settings etc. you must push menu button again when the mode you want is hi-lited. I had a similar problem. Files were loaded (my music is on my harddrive already so I just copy to mp3 player) but when I turned player on it said no files. AHA, I finally realized I had somehow got into the voice mode and I did not have any voice files, so it said no files. I then went to Folder Mode and it only said micin.dir and it was empty, THAT WAS BECAUSE I WAS IN VOICE MODE, when I switched to music mode, they were all there. I know this sounds very rudimentary, but I am pretty computer literate and had no idea how I switched to voice mode. Before I figured this out for myself I called Emerson customer service, they said it was bad firmware and send it back. If someone there had walked me through what I just told you it would have saved me a lot of time. Hope this helps.
Formatting
theres a couple methods....1. use the players software to format. the drive. 2. when you plug it in, go to a command prompt and type in format. and then the drive letter of the mp3 player....thatll do it
Not finding what you are looking for?