20 Most Recent Samsung T220HD LCD Monitor Questions & Answers

Power up issues on the T220HD monitor are caused by a failure of the capacitors on the IP-49135b power supply board that this unit uses. The repair is easy, you just need to replace the 7 failed capacitors and the unit should be as good as new. Here is a link to some information showing what needs to be replaced to repair the power supply board.


I hope this helps.

Samsung T220HD... | Answered on Feb 04, 2021

There should a button on the monitor to switch the input. Press it until you see HDMI on your screen.

Samsung T220HD... | Answered on Oct 19, 2014

are you asking for
a p/n
or a manual.

the powersupply is inside the monitor.
you it removed?

Samsung T220HD... | Answered on Oct 24, 2013

Good news. These monitors come with 3yr warranty. Contact Samsung.. I just did.

Samsung T220HD... | Answered on Jun 10, 2012

click start control panel sounds and audio devices select advanced there might be a tick in the mute box untick it in XP

right click on the speaker icon in the bottom toolbar select playback devices should be a green tick in the speakers if not right click select configure also check the communications tab make sure the are not muted

hope it helps W7

Samsung T220HD... | Answered on May 29, 2012

1) Pull the stand out of the bottom of the monitor (it isn't held in with any screws).
2) Remove the two screws now revealed by the removal of the stand. These are the only two screws holding the rear panel on.
3) Slide a couple of old credit cards into the gap between the front and back panels starting from where the base inserts. As you lever the two panels apart, slide the credit cards along the gap to stop them from clipping back together.
4) Insert a flat-head screwdriver into each of the little slots at the bottom of the monitor and start to lever the back panel away from the front bezel.
5) Carefully use the screwdriver to prise the back panel away from the monitor, starting from the gap you created using the first two slots and working your way gradually around the frame. There are tiny clips every three inches or so all the way around. Each one will release with a fairly loud 'pop', but don't be too concerned - if you're careful, you won't do any damage (use just enough force to get it to release, without using so much you smash anything).

The plastic IS fairly soft, so do your best not to damage it - using credit cards between the screwdriver and monitor will help to protect it; but then if you're doing this, I doubt your monitor is under warranty (and you won't see the small scratches and indentations you make anyway, as they're on the back of the monitor).

Samsung T220HD... | Answered on Jan 23, 2012

Good day!!!

That problem is usually cause of bad inverter board..

Inverter board looks like this:


This board is easy to find..After you open the back cover that board is visible..

Please try to replace it then back to me if have any problem

Samsung T220HD... | Answered on Nov 29, 2011

There is most likely physical damage inside the monitor, it may be as simple as a connector needing to be reseated or reconnected. If you aren't competent to undo the monitor and inspect find someone who can undo it and inspect for physical damage. It will most likely be obvious once you inspect. If it is the connector to the screen you may have to scrap the monitor.

Samsung T220HD... | Answered on Oct 31, 2011

Not finding what you are looking for?
Samsung T220HD LCD Monitor Logo

126 questions posted

Ask a Question

Usually answered in minutes!

Top Samsung Computers & Internet Experts

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers


Level 3 Expert

85239 Answers

Lee Hodgson
Lee Hodgson

Level 3 Expert

4810 Answers

Are you a Samsung Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Samsung Computers & Internet

  • Samsung Computers & Internet

Most Popular Question

samsung t220hd turn back from standby

  • Computers & Internet