Jl Audio Slash v2 500/1v2 Car Audio Amplifier - Answered Questions & Fixed issues
Have a JL audio slash 500 that isnt putting out
Yes it possible that the inputs have been damaged on the circuit board of the amp. If the amp has hi level inputs you could try running a speaker wire input to it and see if it works. You might try another pair of rca cables to.
My sound cuts out and the power light blinks
the amp it going into protect mode because there is an internal fault with the amp. it will need to be repaired. best this to do is find a repair shop and let them handle it good luck man
JL Audio 1000/1 v2 distortion problem
Make sure all your connections are tight , really tight . Check ground , make sure it's to clean shiney metal. Three subs are going to have a low ohm load if paralleled . These amps are not 1 ohm stable ,if below 1.5 ohm's you will have problems. They need to be series paralleled to raise the ohm load. These amps put out the same power from 4 to 1.5 ohms.
6/22/2014 11:45:41 AM •
Jl Audio Car...
•
Answered
on Jun 22, 2014
•
268 views
JL W6 ohm wiring issue
Parallel , all positives together , all negatives together . With 4 ,4ohm voice coils in parallel you get around 1 ohm .
6/22/2014 11:37:17 AM •
Jl Audio Car...
•
Answered
on Jun 22, 2014
•
592 views
Not finding what you are looking for?