Top 20 LG 37LG30 37 in. LCD HDTV Questions & Answers

Necesitarias que cambiar el circuito que recibe los comandos del control remoto;
Abre el enlace y ahi encontraras la parte que necesitas:

LG 37LG30 37 in.... | 184 views | 0 helpful votes

...accidentally pressed enter key to line-wrap sentence? :)

LG 37LG30 37 in.... | 79 views | 0 helpful votes

Take it back to the shop and exchange it for one that works, make sure it works before you leave the shop

LG 37LG30 37 in.... | 60 views | 0 helpful votes

power board failed check the main board the 5 volt side may have a few capacitors blown. check all of them as usually when 1 starts to go rest can follow don't cost much to replace. the ones next to the heat sink are first to start to wear out, use the ratings that are on the old capacitors and replace the same 105c temp rating. and rating to failed capacitors, you will see the faulty capacitors they will have blown bowed tops or a liquid on the bottom of them

LG 37LG30 37 in.... | 138 views | 0 helpful votes

The problem is bad electrolytic capacitors on the back lights power invert board, you need to open the back cove up to change the capacitors.

LG 37LG30 37 in.... | 83 views | 0 helpful votes

Main system control memory IC fault. This is a very small IC; have 8 solder terminals, and can be located very near to the main system control-chroma IC. Check and replace it. Be sure to replace it with the same number printed on it; in all respect. Otherwise, it won't go.

LG 37LG30 37 in.... | 48 views | 0 helpful votes

Fault to the main power supply regulator section. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.

LG 37LG30 37 in.... | 57 views | 0 helpful votes

Sounds like a bad HDMI i/o board, I have it happen on my receiver before. Try different cables? Try different devices?

LG 37LG30 37 in.... | 66 views | 0 helpful votes

Try a hard reset. If it do not help you, its main board is faulty, and should be replaced. There are two types of reset to TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight; will be better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.
Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.

LG 37LG30 37 in.... | 175 views | 0 helpful votes

Here is a link on how to put it on. Removal is just the inverse.
LG 223000 Owner Manual Stand Installation

LG 37LG30 37 in.... | 71 views | 0 helpful votes

Most TVs do not have Bluetooth. Use cables to connect to TV.

LG 37LG30 37 in.... | 669 views | 0 helpful votes

your owners manual doesn't show a listing for programming any cable boxes. your particular transmitter apparently has no cable button operation.

see the following web site for the download of your manual & then the listings for codes for various sources begin on page 124

LG 37LG30 37 in.... | 97 views | 0 helpful votes

Back-light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.

LG 37LG30 37 in.... | 72 views | 0 helpful votes

hi there is a video on youtube showing you how to enable you to use the usb hope it helps


LG 37LG30 37 in.... | 107 views | 0 helpful votes

It depends with which digital receiver you own. If it is a free to air then you will need a firmware to unscramble But if it is subscription receiver then contact your service provider or use the software above at your own risk.

LG 37LG30 37 in.... | 940 views | 0 helpful votes

Most likely "AV Mode" button(has orange circle on it) on the remote has been put on wrong setting push repeatedly untill corrct setting is reached, I believe it will say "normal" or "standard" Hope this helps.

LG 37LG30 37 in.... | 75 views | 0 helpful votes

Sounds like the problem could be in the power supply of the TV. Have a technican check for defective capacitors if you're not equipped to do the job yourself.

LG 37LG30 37 in.... | 334 views | 0 helpful votes

Not finding what you are looking for?
LG 37LG30 37 in. LCD HDTV Logo

262 questions posted

Ask a Question

Usually answered in minutes!

Top LG Televison & Video Experts

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

The Knight
The Knight

Level 3 Expert

76407 Answers


Level 3 Expert

85239 Answers

Are you a LG Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LG Televison & Video

  • LG Televison & Video

Most Popular Question

lg lcd hdtv hit lighting try repair

  • Televison & Video