Top 20
Kenwood KVT-512 Car DVD Player Questions & Answers
Kenwood kvt-512 mecca error
Blue wire is your amplifier remote or power antena, if you ground it and turn the radio on you burn somethin hopefully j6st a fuse.. You did check the fuses, when in doubt the chassis of the radio is also your ground.
Installing aftermarket radio, there are two power lead that have constant voltage, neither of the lead have power
More than likely, you shorted out a wire and blew a fuse. I have worked on cars for 19 years now and have several years under my belt as an electrician - and these things happen. Do yourself a huge favor from now on, spend the extra 25 bucks at best buy for the factory wiring harness adapter. It'll save a lot of headaches for you later on when you change the stereo back to sell the car, or install something else. I learned this the hard way myself. It is well worth doing things right the first time!
My touch screen ribbon is
1.You can only use the device to connect to your Car DVD that have been recommended by the manufacturer > the manual states that an Ipod can be connected.
2.Here are the distributors for the parts that you need listed below:
http://www.kenwoodusa.com/Support/Parts_Distributors/
you may also obtain a service manual through these distributors.
Retro fitting other devices to a consumer electronic device may damage the unit and render it a non working device.
To repair or service Kenwood devices or electronic you have to be authorized to do so.
Here are the authorize repair facilities:
http://www.kenwoodusa.com/Support/Where_to_Buy/
Ive got a kenwood kvt-512 n im tryin to hook an
Your unit should have 2 plugs in the back...one for the audio and power wires to connect to your factory connections and the other plug is just RCA connections for your video, subs and front speakers. If you have a 4 channel amp and a amp for your subs, you will have to split the 4 channel amp down to 2 and run them to your front RCA connections. Subs will connect to the sub connections. If yours are not listed then you may have to track down a wiring diagram. Hope this helps.
Not opening no power was
if you dont have power, one of your wires came loose, either pos or neg.
Please accept solution. We ask you to leave a rating by clicking 1,2,3 or 4 Thumbs Up! and any feedback is appreciated.
Best Reguards, Premium FixYa Support
Dvd not play
A lot of the video screen units are on a lock down mode unless the parking brake is set on your car as a safety feature to make sure you are not watching while driving, there are ways to bi-pass this safety feature but do know it is illegal in some states. Trying YouTube for a way to bi-pass your safety feature sometimes its a lot easier than you would think.
Don't know code for radio
Radio code is specific for each and every car.
It is specific like anti theft code.
You can get it by providing your VIN# and registration details in
authorized dealership. Nobody else can provide you. If anybody can
provide you that , then there is no meaning of security for your car.
I have the kenwood kvt
Hi nickskura,
You system is in "protect mode". The receiver goes into protection mode to keep it from causing damage to itself. Please connect your speaker wire and terminals at the speaker. Ensure the it's not shorting and no bare spots.
Hope it helps.
Thank you for using FixYa.
Radio doesnt want to come
Are you absolutely 100% positive that the antenna is properly seated in the connection?
If yes,
Try changing the station settings. Some have "local" and "distant" that may/may not make it come in clearer.
Refer to your manual for radio settings and play with them a bit.
I have a Kenwood KVT-514
it sounds like you are using an amplifier. if so you are probably using the blue wire (antenna remote turn on) instead of the blue/white wire (amplifier remote turn on) to turn the amplifier on. the power antenna remote wire turns off when leaving tuner mode.
Security problem pas.
First of all, here is a direct link to the ONLINE USER'S MANUAL for that model:
http://manual.kenwood.com/files/B64-4021-00.pdf
To view the Owner's Manual with Operating Instructions just use your mouse to click on the link, which is the underlined and highlighted text just above. This will open a new web browser page automatically for you and allow you to view the information at the website indicated and the contents of the Owner's Manual.
You may need ADOBE READER installed on your computer to read PDF documents. You can download this free at WWW.ADOBE.COM if necessary. Click on the DOWNLOAD ADOBE READER button on right side of the ADOBE home page when you get there, and then just follow the onscreen instructions to install it.
See page 70 of the ONLINE USER'S MANUAL for detailed instructions on how to set up the security and parental lock code features of your unit. If the device is asking for an unlock code, try entering KCAR with the remote.
Please comment back here to this page if you have any questions, have difficulty accessing the links, or just require further general assistance and I will respond as soon as I see it.
Thank you very much and good luck.
Joe.
Dvd video i can,t see
it
You need to make sure the parking brake lead is hooked up from the radio to the parking brake, and that the parking brake is engaged.
Not finding what you are looking for?