20 Most Recent
Toshiba E-Studio 3511 Color Copier - Page 4 Questions & Answers
Getting error sc 479627 toshiba e studio 3511
479627 is your meter not the error code.3511 and 4511 color machines will be obsolete at the end of this month. Advise you call your local Toshiba dealer and talk to them about a trade in upgrade.
Toshiba 3511 color print problems
Hi,Hope it's not the calibration. This could happen due to transfer belt timing problem. There are sensors and reflectors inside the transfer belt assembly. They may be dirty. Clean them or replace the transfer belt if required.
F120
e-studio 450 f120 Solution
Hi,
My Toshiba E-Studio 3511
I am assuming you have emptied the old waste toner "box" and not replaced it with a new box. This is not a problem, just clarifying. If this is the case then you have toner packed into the sensor block which is telling the machine that the waste toner box is still full. Just look behind the waste toner box and look for a little set of wires. They lead to a small black sensor. Now look at the waste toner box where it mates up with the sensor. You will see a small square box area on the waste toner bottle. The sensor looks thru this block and if it is blocked with toner it will tell the machine the box is full. Just tap on the little block and make sure there is no toner in it and re-install the waste toner box and the indicator should go away.
Good Luck and Thank You for using Fixya.
ı want to know how
[CEA0] = Revolver home position detection abnormality
Need to check the home position sensor on transfer unit, perform input test. ( 03-[FAX]ON/[2]/[C])
)
[CEF0] = Revolver motor abnormality
Perform output test to check the revolver motor. ( 03-450 )
If still cannot solve, try replace LGC board.
CEE0
Hi how are you this is jack my personal ID..(
[email protected])
Dear follow the procedure step by step.
[CEE0] Transfer belt position detection abnormality (Normal speed)
If the error [CEE0] has occurred, check the transfer belt home position sensor-1. If the error [CEE1]
has occurred, check the transfer belt home position sensor-2.
Is there any stain or scratch on the reflection tape inside the transfer belt?
YES Clean the transfer belt or replace it.
Replace the cleaning pad if it is excessively stained.
NO
Are the transfer belt home position sensors-1 and -2 stained?
YES Clean them.
NO
Are the transfer belt home position sensors-1 and -2 working properly?
NO 1. Check if the connectors or joint connectors of the transfer belt home position
sensors-1 and -2 are disconnected.
2. Check if the connector CN361 on the LGC board is disconnected.
3. Check if the connector pins are disconnected or the wires of harnesses are opencircuited.
4. Check if the conductor pattern on the LGC board is short- or open-circuited.
5. Replace the transfer belt home position sensor-1 and -2.
6. Replace the LGC board.
YES
1. Check if the conductor pattern on the LGC board is short- or open-circuited.
2. Replace the LGC board.
More information please mail me ...
Thanks
Best Regards,
Not finding what you are looking for?