Top 20 Toshiba e-STUDIO 282 Black and White Copier Questions & Answers

https://www.youtube.com/watch?v=3aqJtimew-w see time 1:30 - 1:44 on video See the man opening the duplexer tray and removing paper jam !

C440-Heater abnormality after abnormality judgment: The temperature of the fuser roller has exceeded the range of control or does not even reach the range. You can try going into (08) mode by holding 0 and 8 while turning on the copier. Once the copier starts up key in 400 and press start, input "0" and press interrupt. Try rebooting the copier, if this doesn't clear that call for service then you are going to need to get work done on your fuser.

Code 282 is returned to the manufacturer Toshiba

123456

check if there is a bad sector on your hdd, using hard disk checker software for bad sectors, if it has you need to replace it and backup your files. asap.

Clean feed rolls with wet cloth and lubricate registration clutch.

make sure the guides in the paper tray is in aligment with the correct size markings

if you are using the adf, try to check the timing of the rollers...your magnetic clutch might need some cleaning...the moving down or moving up of image is usually caused by missed timing in adf and paper...

check the transport clutch and exist motor

Carriage home position sensor not turning ON

go to user or energy saver key you will find shutdown

Format HDD

press the yellow button (the reset button) than press (1993) and press five times the (stop) or the orange button than you will sea in screen touch panel adjust do the step that are demand in. thank you

Hi Sunil In order for us to assist you with your issue, you will need to provide more information about your problem. What is the issue with scanning?

you can call 1-800-GO-TOSHIBA and they will walk you thru

call 1 800 GO TOSHIBA they can tell you

After replace new hdd, u need to performs following: Update of HDD program data and UI data.1) Create partitions. (In case of using the download jig, this is not necessary.)While pressing [3] and [CLEAR] button, turn the power ON.When "Firmware Version Up Mode" appears on the LCD, key in [3] and press the [START]button.2) Format the HDD. (Setting Mode (08-690: 2))3) Update with the download jig or USB storage.4) Format the HDD. (Setting Mode (08-690: 2))* When the FAX unit (GD-1150) is installed.Start up with the FAX Clearing Mode (1*)Perform the 1*-100 (FAX Set Up), 1*-102 (Clearing the image data) of the FAX Clearing Mode.

E010 is a jam up in your fusing unit. Chances are on that model, you have a pickoff finger stuck in an up position. Check for that, if there is just push it back down with a pencil. Otherwise you may have other problems and will need to contact a Toshiba Authorized Retailer for help.

Very simple. You should be able to google to get the full instructions. The exact phrasing of what you're looking for is "department codes" or "user codes"

replaced your HDD.