Samsung HT-X810T Theater System - Answered Questions & Fixed issues

May be thermal protection issue on component?? check..

Not sure for the playstation etc, but for the TV the manual says using the (not included) optical link between TV and the main unit.

Note that this is not mentionned in all language versions of the manual.

Have a look at this solution: http://www.fixya.com/support/t1942837-dvd_player_reads_no_disc_shows_loading. I used a cotton bud with isopropyl alcohol to clean around and inside the mechanism then cleaned and inserted a DVD.

Mine did the exact same thing today. If you figure it out please let me know. [email protected]

Hi there, please get the code here : www.regionfreedvd.net/ www.dvdripper.org/dvd-region-codes-vs-ntscpal/ www.regionfreedvd.net/players.html
www.dvdreviewer.co.uk/Forums/...region_code/page1
Best Regards, Jay_ed3w5

Hi, Please get the code here : www.dvdoverseas.com/dvd.htm
www.regionfreedvd.net/
Regards,Jay__kjn78

A couple of things you could try...

1. Remove the power socket from the wall and leave out for thirty seconds. You need to actually remove the plug from it's socket, not just switch the unit or plug socket off.

2. Near the DVD tray there is usually a small hole (a little bit bigger than the size of a pin). This is usually a manual eject mechanism. You can use a pin or a straightened out paper clip to push inside the hole which would normally activate the eject mechanism.

probably audio amplifier IC damaged need to be replaced

clean the disc or go to a store and buy that disc cleaner spray

It is just that main unit is looking for the "Wireless sub-woofer" and shows this message when it can't find the sub.
wireless connection between main unit and sub should be reset.

Consult its directions to see if it has a variable audio output, then use it.

I had the same problem. but if you dont put your files in folders it will work. after firmware upgrade it couldn't read folders and it is a stupid thing.

Purchased a x810 & everything tests out fine except TV signal sounds from cable box. We have the Comcast cable box connected to the 50" Samsung Plasma TV hooked up to Samsung x810 Soundbar all using HDMI cables. But we are not getting cable shows sound through Soundbar. Please advise

go to samsungusa.com and look for a listing for codes, or you can go to the store and look at a universal remote package for the code

you can connect the audio output pin in tv R/L channel and in sound systems audio R/L input
and put the sound system in line-in mode..........try

Have you tried other DVD's...you might have a bad one.

If so,,,you may need to clean the laser diode. You'll need cottonless swabs (no lint swabs) and Isopropyl alcohol 99%.

Might be hard to get to, depending on the model, but gently swab the diode lens. Don't saturate it tho.

good luck

On the rear of your TV connect, with a phono/RCA cable to the Audio R + L sockets, connect the other ends to your Yamaha using the TV in sockets. See photos attached Hope that helps. HDMI is for video unless the extra pins are added for audio.

See service manual. There are no fuse in it. Service Manual: SA-WX900 ' PDF ' Loudspeaker ' Electronics (scribd.com)

See page no 65 troubleshooting in user manual YPU4J-CANADA-ENGLISH0.0_0610.indd (samsung.com)

See following link, it may resolve your issue My MP3 Player Is Locked Up (Frozen). ' Samsung Africa