It depends if it is a top loader or a front loader. All question should have 'make model (what it is)' as the first 3 words.
A front loader is easier to fix.
vernel.pt
https://www.vernel.pt > Tips & Articles
From fabric softener not dispensing or not draining to a blocked washing machine's detergent drawer or one filled with water, we take a look at the most ...
I don't have real-time access to specific product information, including Maytag front load washing machines. However, I can provide you with some general information. The capacity of a washing machine is typically measured in cubic feet or kilograms and refers to the amount of laundry it can hold in a single load.
On a Washing Machine? A Top Loader?
Normally water being splashed where it shouldn't be. I would suspect the lid lock switch.
or
Water leaking to the motor, or motor controller board.
There are two wash cycle programs that default to a 30 degree wash for the Logik L814WM16. Set the machine program to Delicate or Eco to get a 30 degree C wash. Note: the Eco program has a maximum load of 2 Kg. The maximum load for the Delicate program is 2.5 Kg but may be lower when washing some fabrics.
There are also programs for Cottons at 20 degrees C and Express 15 degrees C. See page 17 of the manual, available here: https://manuall.co.uk/logik-l814wm16-washing-machine/ .
I hope this helps.
Cindy Wells
E I is commonly a water drain problem. Check the waste pipe isn't blocked and isn't kinked or twisted badly. If these are all OK you will need to get a good repairer to check the drain pump inside the machine. They will also be able to check if there is something else causing the issue.
sounds like there may be an issue with the water inlet valve or the water level sensor in your Hisense WTQ1602S. These components regulate the flow of water into the machine and detect the water level respectively. If they're malfunctioning, it could cause the symptoms you're experiencing.
Question edited for clarity, 'make model (what is is)'.
GE spares suppliers. In most cases, these suspension rods are somewhat interchangeable. Most cities have a spares place where you can go and say "can I have one of these".
https://www.google.com/search?q=GE+TD1355PBAYN+parts
..
There may be a few different reasons why the OE error code can display on your washing machine. Is it the LG washer getting the OE error code? The OE error code on the LG washing machine display is an indication of a NO DRAIN issue. The 3 issues that may cause this fault code is a bent drain hose, the drain pump filter is blocked, or the drain pump may have foreign objects lodged in it making it unable to drain. All these issues can cause your LG washer to display the error code OE. With all these different reasons, checking all 3 components will clear the error and fix your LG washing machine.
master reset....Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved.
The A13 error on a Realstar dry cleaning machine R325 indicates a problem with the machine's solvent level sensor. To fix this error, follow these steps:
Check the solvent level: Ensure that the solvent level in the machine's tank meets the required level.
Inspect the solvent level sensor: Examine the sensor for any damage or obstruction.
Clean the sensor and its surroundings: Remove any dirt or debris that may be affecting the sensor's performance.
By following these steps, you should be able to resolve the A13 error and get your Realstar dry cleaning machine back in working order!