20 Most Recent Fisher and Paykel WA37T26G Top Load Washer - Page 8 Questions & Answers

That means that power is being applied to the drain pump when it shouldn't be. There is only one reason for that, a fault in the main control board. You will have to replace the main board.

would need more info

each element switch controls the heat to that element so those switches need to be replaced ,technical name is simmerstat

The inlet valve must be replaced.

Make sure that the washer drain hose is at least 30 inches above where it comes out of the washer or 38 from the ground. the washers drain hose needs to be typically higher than the washer. Could also be a faulty pressure switch depending on the washer See video link. .https://products.geappliances.com/appliance/gea-support-search-content?contentId=17418

remove pump check foe anything that may be jamming it,at the same time check the copper windings for any discoloration ,if any replace pump,faulty pumps get hot and after a short time switch off due to a built in thermal cut out

Hi, you should beable to put a thin knife into the slot on the little door flap at the front on the right side and gently pull the door flap down, then unscrew the plug and the water will drain out, put a larg try underneath to catch the water, best to undo the plug enougth so that when the tray is full you can tighten the plug why you empty the tray, all the best.

You may need new brushes in the motor

it wont spin if there is water remaining in it,check pump for restrictions or anything jamming it if good replace pump

HI - A 708 EH! A BIT OF AN OLDIE - ANYWAY THE PROBLEM SHOULD BE THE DOOR SWITCH NOT OPERATING.

OK - to repair - unplug the power source - remove 2 screws back top corners, lift the display unit & lay on the lid - on the right side got all the wires going down the machine - locate the first plug has 4 wires , wh - Y- Bl & Bl - BK/BL are thinner and both goes with the rest of the wires & the other 2 you will note goes under the controller - cut & strip the BK/BL so the copper is exposed - use a proper elect connector twist together these exposed wires & join inside the connector.

Assemble & enjoy.

CAUTION - this in effect will overide the lids effectiveness - whilst the machine is operational the opening of the lid will not pause/stop the machine in its tracks like how it should be. Be wary the user safety has been compromised - otherwise try to obtain a replacement if still available for these particular series...

Cheers

blocked or faulty drain pump, remove check for any objects stuck in pump.sniff pump for any burning smell if so replace pump

Does it beep when you switch it on at the wall Are there any lights showing on the display when you push the power button? or does it seem completely dead

I found this..maybe it'll help!? http://www.essentialbaby.com.au/forums/index.php?/topic/532059-help-my-washing-machine-is-staining-our-clothes-need-ideas-on-how-to-rectify-problem/ I have no idea what napi san is cuz i'm in minnesota usa. hope this helps!

It's best to use a film of petroleum jelly rather than any grease

This video should solve this problem. Especially watch it from 1:07minshttps://www.youtube.com/watch?v=-ibZ7CU-hVM

This video will help for error codes 240, 130 and 131 https://www.youtube.com/watch?v=pUrtHJ-1kPI

It could be your main bearing going bad

I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years