Top 20
KitchenAid Kitchen Aid Kitchenaid 5-speed Ultra Power Blender Blenders 5-Speed Blender Questions & Answers
Problem with soup mate,all lights flashing but nothing happening
If this is a Kitchen Aid blender with the flashing lights then you will need to remove the motor base cover and check the motor for a circuit. If it is open circuit then either replace the motor or locate the thermal fuse (under some white tape and aluminium clip on one of the field windings) and either replace or bypass fuse if it is open circuit.
5/19/2014 7:58:12 AM •
KitchenAid...
•
1,164 views • 0 helpful votes
How to repair tefal 8143 dough mixer
You could try asking this in the Tefal part of this forum instead of the Kitchen Aid area as folks who know Tefal may not be browsing this area. You could also be a little more specific about exactly what the fault is that needs repairing.
7/15/2014 2:58:40 AM •
KitchenAid...
•
217 views • 0 helpful votes
Why is the unit not turning on?
Check the motor for continuity, it may be open circuit. If it is locate the thermal fuse covered with insulation tape on one of the field windings (where the metal clip is) Check that for continuity, if faulty bypass or replace it.
6/28/2014 4:10:49 PM •
KitchenAid...
•
224 views • 0 helpful votes
Changing the coupler
Lever it off with a screwdriver, it is aluminium and the threads on the ring will break away. Pick them out of the thread on the motor shaft and screw on a new coupling, it will be left hand thread.
4/22/2014 6:03:05 PM •
KitchenAid...
•
288 views • 0 helpful votes
Replacebrokenmagnet
Magnet is not available as a separate part, you need to buy a new motor and be more careful in the future.
3/30/2014 2:46:17 AM •
KitchenAid...
•
199 views • 1 helpful votes
Dishwasher doesn't fill and spin
Try asking this in the dishwasher department, asking it in the blender dept will invite unhelpful replies like this 'cos I know nuthin' about dishwashers.
2/8/2014 2:04:13 AM •
KitchenAid...
•
114 views • 0 helpful votes
How to separate coupler
Assemble it with motor secure and base & feet on. Drill 3 or 4mm hole in edge of coupling Put screwdriver into hole on a large angle and whack the handle to undo the coupling. You are whacking it to turn in the same direction it turns when the motor is running.
11/20/2013 5:26:31 AM •
KitchenAid...
•
146 views • 0 helpful votes
Diishwasher not cleaning
1. Make sure your spinners are not blocked when your dishes are loaded. 2. Make sure you are using a good enzymatic cleaner like "Electrasol." This type of cleaner eats the food off of dishes and it is very effective. 3. Make sure the water is HOT when your dishwasher is running (open it during the cycle and check the temperature.4. Lastly, consult your manual or an online manual for troubleshooting tips for your model when it appears to stop cleaning.
2/27/2013 4:43:41 AM •
KitchenAid...
•
76 views • 0 helpful votes
Not finding what you are looking for?