20 Most Recent Krups XP7225 Espresso Machine - Page 2 Questions & Answers

it is a common issue. See the posts for xp7240. The seal within the plunger is worn or dirty or the valve is sticky. Posted both instructions on other posts.

Krups XP 4020 Semi-automatic Espresso Coffee Maker http://www.coffeemachinemanual.com/krups-xp-4020

are they shorted ? see if thermal blown

what is you model ples

what is you model sir

Krups XP1500 Instructions ' eHow

www.ehow.com > Home

Krups XP1500 Instructions. The Krups XP1500 is a coffee machine and espressomaker with a 10-cup coffee capacity, pause and serve feature, non-stick ...

KRUPS XP1500 USER MANUAL Pdf Download. - ManualsLib

www.manualslib.com > ... > Coffee Maker > XP1500

Translate this page View and Download Krups XP1500 user manual online. Krups XP1500: User ... Coffee Maker Krups ESPRESSO COMBI XP1600 User Manual. (51 pages).

Krups 867 Instructions For Use Manual - ManualsLib

www.manualslib.com > Brands > Krups Manuals > Coffee Maker > 867

Coffee Maker KRUPS ESPRESSO NOVO 2100 PLUS Instructions For Use Manual ...Coffee Maker Krups XP1500 User Manual ... stronger brew than regular grammablecombination ber to NEVER open the coffee, espresso, and coffee.

Check the water float in the tank, it is common for them to cease floating sometimes. Krups solution is a new tank, my solution is to jam something plastic underneath it to lift it up so that it activates the sensor. Even if tank is empty it will no longer ask you to fill it up.

I don't think there is a lot you can be doing wrong to cause that apart from maybe something not too well cleaned and creating a restriction for the steam.

You will need an instruction manual, if you leave your email address I will send it as a PDF file.

Open the machine up and look for a broken hose or similar.

That is a very uncommon error code. It is not detecting the ejection switch pulse, it may be just a case of dismantling and cleaning and checking the switch operation. It's all internal so you need to remove the housings.

Look for and remedy any internal leaks. If error 6 remains then expect to replace the distributor assembly.

Direct from repair manual for your model, these are the possibilities - Fault in the actuator high position switch (mechanical or electrical) - Distributor switch fault - Faulty electronic boards connection - Actuator switch short-circuited

If the pump is pumping it must be going somewhere, it cannot be compressed. There are many, many possibilities on those things.

To make it finer you need to remove the top housing and look at the top of the grinder. Notice the white part at the top with an arm on it that engages with the lever from the adjustment knob. You need to remobe the white part from the top of the grinder and turn it back (anti clockwise) a couple of notches and re-engage it. It would pay to make a note of the original position, you cannot move too far from that.