I have a EIDW6105 Electrolux dishwasher and it will not fill with water. Can hear a humming but no water entering the tub. Water is set on 120 degrees and and no lines are cramped.
open the door,look on the front of tub i believe your float switch is on the left side,make sure nothing is under it holding the float up,this will stop the water from entering,if that's ok you could have frozen pipes or valve,i've seen a ton of them in my area,or a bad house water shut off or a bad water valve on dish washer part 154513601,remove the bottom panel you'll see the valve on left side,you can crack the fill line with a wrench and see if any water comes out,if the valve is humming most of the time this is from no water getting to the valve,if it's frigid temps. where you live most likely the pipe or the valve is frozen,you can get a hair dryer and heat the valve up to see if that helps but make sure your shutoff works under the sink,also at night leave the doors under the sink open and remove the bottom panel to the dish washer all winter so warm air can get under and around the valve and pipes,if it isn't froze shut off the water at shutoff under the sink,remove the water fill line from the valve syci the line in a bucket or glass and open the shutoff,if water comes out the valve is bad hope this helps.
