20 Most Recent Maytag MFD2562KES Stainless Steel Side by Side Bottom Freezer French Door Refrigerator With Ice Box - Page 4 Questions & Answers


Look inside the refridgerator and find the drain, make sure it is clear and if neccesary put a few drops of drain claner fluid into it.

Maytag... | Answered on May 04, 2019


Check that the return air duct near the bottom of the fridge is not blocked. The air may be going into the fridge but cant get out. It has to complete a cycle where it gets drawn back into the freezer to get cold and then gets blown back into the food compartment. The baffle controls how much or how little cold air goes in. You may have to take the rear panel off the inside of the freezer, there may an ice buildup in there.

Maytag... | Answered on Apr 10, 2019


I think you mixed the F and the D in the model# so it should read MFD2561HES instead.

There are a few things that can cause an ice maker to stop working. Firstly, would be the temperature inside the freezer not being cold enough. It should be as close to 0' F as possible.

There is an inline fuse that sometimes, but rarely blows. When you changed the icemaker, did it come with a new harness or did you swap the one off the old icemaker onto the new one? Removing the harness and ohming the black wire ( The one with the white piece that clips onto the bottom of the icemaker) will determine if that fuse is still good. Without knowing what happened to the old icemaker, I would not rule that out!

More commonly, The water solenoid goes bad and will let the icemaker cycle without giving it water. Sometimes it goes completely dead while most often it fails to close completely. When this happens, it allows water to "drip" and usually freezes inside the water fill tube. ( Think of your kitchen faucet.. When they start to go bad, they will not shut off and needs to be jiggled to stop it from dripping) If this happens, the fill tube will need to be defrosted after a new valve has been installed. Defrosting the fridge is recommended as you can damage the inside if you use a hairdryer or some other form of rapid heat.

The sizzling sound you hear is most likely the fridge in its defrost cycle. During this time, you would not hear it running and it would get louder when the freezer drawer is opened. It would sound similar to water drops hitting a hot stove. This is completely normal and happens randomly! Do not panic over this!

Maytag... | Answered on Apr 04, 2019


It may help to take the ice maker plastic unit out of the refrigerator and rinse with warm water, then dry. There may be ice blocking the flap from closing. Also, check to see that the plastic unit is fully seated as it should be in the refrigerator itself.

Maytag... | Answered on Apr 03, 2019


Did you do it yoursel. It may b the fan. Check for pipe blockages. Call a repair man. If you have his work will b warranted

Maytag... | Answered on Apr 03, 2019


Pull out from wall and expose radiator. If dirty, vacuum or blow it clean.

Maytag... | Answered on Mar 31, 2019


hi. this drain is in the panel of the refrigerator in the Botton.were the lights at ,, take this panel and you will find the drain

Maytag... | Answered on Mar 25, 2019


Unplug it for a couple of minutes, Try again. It may have been hit with a surge. IF that is the case, you are looking at main control board and some money. Contact your homeowners insurance if a surge has damaged it.

Maytag... | Answered on Mar 24, 2019


Another area to look into is the control panel itself. Due to moisture seeping under the plastic filament the touch buttons / leds may stop working

Maytag... | Answered on Mar 09, 2019


Hi! Please check the manual. There should be info or a contact of their customer support. https://manualsbrain.com/en/manuals/1401540/?page=17

Maytag... | Answered on Feb 28, 2019


Give it about an hour. May have gone into defrost mode.

Maytag... | Answered on Feb 11, 2019


Program code is located on the serial plate

Press and hold the Door Alarm keypad.

Press and hold the Freezer Temperature Down keypad within 3 seconds.

Release the door alarm keypad and wait 3 seconds.

The control will display PE to indicate the programming mode.

Press the Freezer Temperature Down once more.

The control will display the current Program Code. This should be the same as the program code on the serial plate. If the code is correct, press the Door Alarm keypad for three seconds to exit.

Press the Refrigerator Temperature Up keypad or Refrigerator Temperature down keypad to change the digit value. The decimal point indicates the selected digit. Press the Freezer Temperature Up keypad to select the next digit. Once the correct program has been entered, press and hold the Freezer Temperature Down keypad until the program code begins flashing indicating it’s been saved. Exit the programming mode by pressing any key.

Maytag... | Answered on Jan 16, 2019


Pull fridge out and make sure everything isn’t covered in dust.

Maytag... | Answered on Jan 07, 2019


Did you Press and Hold the "Filter" button for 5 seconds?

Maytag... | Answered on Jan 07, 2019

Not finding what you are looking for?
Maytag MFD2562KES Stainless Steel Side by Side Bottom Freezer French Door Refrigerator With Ice Box Logo

Popular Tags

4 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Refrigerators Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2027 Answers

Are you a Maytag Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Maytag Refrigerators

  • Maytag Refrigerators

Most Popular Question

cannot reset filter light our maytag

  • Refrigerators
Loading...