20 Most Recent LG LFX23961ST Stainless Steel Bottom Freezer French Door Refrigerator - Page 8 Questions & Answers

I know you can find aftermarket filters at a lower price, but I'm a fan of OEM parts. Have had too many disappointments with the cheap, Chinese parts.

https://www.appliancepartspros.com/lg-filter-assembly-head-5231ja2005a-ap4440605.html

Turn off the water supply, put a towel under the filter compartment, turn the old one CCW, put in the near one and turn CW. Reset the indicator by pressing and holding for 3-5 seconds.

Download here: https://www.lg.com/us/support/manuals-documents?customerModelCode=LSC27931ST&csSalesCode=LSC27931ST.ASTCLGA&category=CT10000021&subcategory=CT10000063

whats the question?

first maybe Adjustment button has locked or LED is burn, other refer(troubleshoot) & user guide for more guidance

Voir d'abord ces aides, probablement un bruit normal. https://www.lg.com/us/support/help-library/refrigerator-noises-CT00023125-20150292153479

My problem was similar to yours and my lg refrigerator model number is: LMXS30776D/02, I followed the steps like you with no luck. I just fixed mine last night and it's a pleasure for me to share with you my experience.As I was trying to figure out what was wrong with my fridge, as I was shaking and lifting the left front door of my fridge I noticed that the error code E: 15 disappear on the display. As we open the door back and forth for normal use,the error E: 15 comes back again.From that,I realized something wrong with the left front door of the fridge. I ordered a new left door, It came in yesterday, I installed it last night and everything works beautifully in my fridge, no more code what so ever. as a result, if you are experiencing the same problem,most likely you need to think replacing the left door of the fridge. Let me know if this help. Thank you.

Well unless its a solar powered ice dispenser and the sun has'nt set yet, you

Check the line that goes from the water pipe to the back of the refrig. Someone may have used something they shouldn't have. The lines in the refrig won't break down like that.

How did you remove ice from freezer. If you uses any type of tool (Scraper etc) then you have possibly punctured the evaporator tubes. These tubes can be either as a radiator type or form part of the freezer box and are very thin therefore susceptible to puncturing when using scrapers or such to remove ice. To remove ice from refrigerator condensers allow it to melt, you can use a hair dryer to speed this up but DO NOT use mechanical means.

Take the filter out and examine the seals that are on it. Make sure there are no burrs or gouges. Put some shortning on it for lubrication, reinsert.

it could be your evaporator fan that's located in the back of your freezer being blocked by ice buildup. you will have to turn off the light by either using a magnet or pressing the light switch off so fan will run while door is open. Fan will not run while door is open and light on. Do you have frost buildup on rear wall of the freezer?

This unit lists 2 separate water valves, which one did you change? MJX62831301 AJU72992603 Did you check for power at the water valve moles plug?

Check you water solenoid. Could have debris in the tiny inlet strainer

Try and un-plug the fridge for 10 minutes, then plug it back in. It should reset. Make sure the arm is in the down position inside the ice compartment.

You can our web browser and Google exactly what your looking for with it's model number. or you could just go to the LG.com website, they should be able to help. And there's an appliance parts store i used when i needed a door latch for my front loader washer. But they do have almost everything. And there not to expensive. Try Thrifty Appliance.com. Good luck. Lynn

Only frost free models have a drain and that is recognisable by a funnel shaped moulding in the plastic of the cabinet liner terminating in a hole. Frost free models have a heating element that is switched on briefly after each cooling cycle, melting any ice that has formed over the evaporator. The resulting water droplets are channeled into the drain by the funnel-shaped moulding. The drain leads to a tray fixed to the compressor and the heat from the compressor causes the water to evaporate. The best thing to check if the drain is clear is a flexible curtain wire and for a good clean a variety of suitably sized brushes are available. Sometimes the insulation of a fridge or freezer becomes sodden with water and ice tends to build over that area. Where the drain runs through an area of sodden insulation where ice is forming it can be impossible to clear the drain. Check the outside of the cabinet for cold spots. The presence of a cold spot indicates the insulation is failing and it is time to replace...

We just did ours a few days ago. LG-GR419 could be similar to yours. Freezer part. We found the bottom drawer stuck with ice - frozen water dripping out from the drain. So, took three screws out. Due to the drain being frozen (could be a result of someone leaving the freezer door open at some point and then just closing it after some melt...the back panel will come off with a tug - after the ice behind it melted. We used a hair dryer to do this - sparingly. Can't afford to melt any plastic. Then once tugged off, we saw a layer of ice in the tray and defrost that with the hair dryer - until everything is clear. At the back of the fridge, we took off the panel - cleaned the dust clogging the slits - my Goodness, no wonder the fridge was working so hard! Chockablock! Anyway, traced the drain hole to a tube. But at that point, not sure why the drained water doesn't go through the tube - perhaps it is not meant to...maybe it is a slow drip and the fan at the back evaporates the water collected - so that was it. So far, it is back to normal. We also found it quieter.

1. Tray is worn or hard water build up
2. 5989JA1005H ice maker assembly
3. You could try removing it and then clean the cube tray with a ice maker descaler and then use a food grade silicone spray to coat the cube holes and follow the manufacturer directions.
4. But I would just change it and be done.