20 Most Recent Andis AGC Super 22360 Hair Trimmer - Page 4 Questions & Answers

Ask Mannys-Sharpening.com for Andis Manuel try their email at [email protected]

With the clipper running, grasp the blade set by the edges and flip it down away from the clipper on its hinge. Simply slide it forward off the tang and slide another blade while the clipper is running. Snap it up toward the clipper and you're set.

try www.angliaclipperservices.com for andis clippers and blades

hi try www.angliaclipperservices.com

On this type of Andis Trimmer the most common problem is the switch it has a rocker type switch, they go out every time. mannyssharpening.com has the replacement switch but a better type. [email protected]

Hi there that's screw are there for adjusting the height. I mean when you full tight it then its will touch the skin & little **** the screw it will not touch the skim just go from top of the skin. Its mean not a clean shave.
When you full open the screw then the blade came out in your hand. Its also the way of changing the blade Hope you understand me. Thanks & waiting for your feedback.

lever adjusts the depth or cut

Some shavers require you to put some oil on the blades, i have a pair, i just splash a small amount of water on the blades, and it works just fine.

Most makes of clipper including Oster, Andis, Wahl have a latch which is depressed to release the blades. The latch is commonly situated under the hinge assembly and holds the blade with a simple hook at the tip which catches on the blades.
If the blades will pull off without depressing the latch, chances are the tip has broken off and will require replacement.
Undo the two screws securing the hinge into place and remove both parts, when fitting the new latch make sure the spring ends of the hinge locate through the holes on either side of the latch.

hi, not sure of the sharpener you have but to be honest it is very hard to sharpen blades getting the correct hollow grind is essential we receive lots of blades that have been ruined by other sharpening companies.

possibly make sure the blade locks into place could also be a problem with the blade drive assembly.

I took my andis ceramic edge blade apart to clean. Now my clipper will no longer cut my dog's hair

Why Invest in Healthcare Property