Top 20 Staples SPL-P500 Printing Calculator Questions & Answers

Your calculator is fine. It is an adding machine first, so it uses adding machine logic and you hit the star button to print the total on the tape. The equals sign is only used when multiplying and dividing. Adding machine logic is as follows: 5+ total 5 3- total 2 7+ total 9 * print out total Good luck, Paul

Try making a point and feed it in the right place, the feed roller which is only about 1/2 inch wide should pick up the paper.

Try calling the company

https://www.mybinding.com/media/manuals/swingline-assorted-breeze-automatic-staplers-42131-manual.pdf https://www.youtube.com/watch?app=desktop&v=QkkQH8vY9zM

Usually a jammed or bent staple in the throat at the end.

Question edited for clarity and typos. Either mains voltage instability, or the internal switch has gotten a 'hair trigger'. Clean and lubricate. https://www.google.com/search?q=rapid+5080+electric+stapler+troubleshooting ..

It is likely that you are having a mechanical problem with the stapler in this situation. Check to make sure the spring-loaded chute is open and not jammed in the closed position after making sure the stapler is empty of any staples. Try putting the stapler arm back into its resting position by applying pressure on it. If this doesn't work, you'll probably need to disassemble the stapler to find the problem and fix it.

ask or go into a staples near you

https://www.fixya.com/support/t18412900-staples_shredder_spl_txc15a_power

staples web site or customer service

Maybe the calculator could be broken then or the battery is low if it takes batteries.

I don't think taking it apart will help - when staples don't bend behind the papers, assuming the correct staples are used, it is usually either the anvil is worn or there is some misalignment between the staple and the anvil. The anvil is usually the part that wears out first, fortunately many office staplers use a dual anvil that can be turned around to select the staples being bent outwards. This position is ideal when the staple will need to be removed at a later date. Staples are usually produced with a sharp square end to each leg that after a few thousand staples will have done some damage to the anvil or a few hundred if the anvil had slipped through unhardened. I suggest you take a look under strong light and magnification and compare it with that of a working stapler...

logic says to try staples....

Usual cause is paper jammed in the cutting heads.

try removing the batteries and reinserting

Hi there, its either full, has a jam or one of the compartments may not be fully closed. Check all of these things. It may also be overheated unplug it and wait a few and plug it back in 5-10 minutes is about a normal wait reset time for shredders . Good luck https://www.6ya.com/mr.mike

I searched using https://www.google.com and saw several youtube videos on how to load staples. Examples: https://www.youtube.com/watch?v=_RmOcaeoRZ0 https://www.youtube.com/watch?v=M8HC37xaiXw

new battery and still not work it is time replace it,

Not necessarily a lost cause but it will need a close examination of the innards in order to discover the problem and general condition. There is quite a bit of information online... https://www.google.com/search?rlz=1C1CAFB_enGB673GB676&q=Staples+Shredder,+SPL-TXC122A&spell=1&sa=X&ved=0ahUKEwiX5qGBoK3fAhXLxoUKHQbfDvwQBQgrKAA&biw=1366&bih=657

Ck for jambed staples. Make sure you are not trying to load too many staples. Shorten the stick.