20 Most Recent Reddy HEATER RLP30 30,000-BTU PORTABLE LP PROPANE FORCED AIR HEATER - Page 3 Questions & Answers

No it not, Sounds like the bushings are worn. It is time to replace motor. the part number is fasco 105336-01.

Possible the thermocouple bulb has slipped out of position and isn't being heated as it should. If it is a model with a pilot light, perhaps it is blocked. The thermocouple is probably the most likely culprit.

The electrodes might need cleaned. I am attaching a link, please check out the FAQ section, then scroll down and click on FAQ for spark plug heaters. I hope this helps. Reddy Heater Parts Sales Online Mr Reddy Heater Parts Master Heater Parts...

Difficult to comment without knowing what function the circuit board has. Heaters of this type usually need a high voltage supply to produce a spark at the ignitor. The high voltage is typically produced by a transformer which historically is highly stressed and unreliable in some types. Your heater might be differently designed but it is fairly clear the ignition spark is absent...

You might have to call a Technician to service your unit

Check thermocouple

Could be flame sensor .Just take it out and clean

Jerry Mcgee answered this question here on FIXYA.. If a drop of water passes through the system and causes a momentary flameout condition, the photocell tells the control board to shut down- and it does. The photocell has done it's job. The ignitor only gets red for the first 5 seconds of burn-time, then the flame keeps itself going, at least until the water passes. Since water doesn't burn the flame goes out and there is nothing to restart the flame.

What part do you need from this picture? number pleace

the fuel to use will be on the specs plate attached to the unit as different fuels have different calorific values using different fuels for which the unit has been designed to use will cause smoke and other operational problems if there is no specs plate attached , contact the manufacturer and get the details from their engineers

Hi Kaza. see if this link helps you out. reddy heater 170t turns on and runs for few mins then shuts off Google...

I would check the thermocouple

Should be on the data plate. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

I would google the company they should have a manual you can down load from there site

The thermisistor is probably going bad and if the temp rises above above what it's sensing (in it's faulty condition), it will cause the unit to shut off. Also, make sure that when you are putting on the cover, it's not pushing on any internal parts and wiring.

There are couple possible reasons your unit refuses to fire; some units tjis big have to be level, this is a saftey feature bulit in if it is not level, it will not fire, ( it believes it has been tipped over), the smell of propane could also mean it has a leak on your line connection ( bad fitting, not sealed properly), finally check the temperature sensor may be bad and need replacing......