20 Most Recent JBL MCDC100 6-Disc CD Changer Questions & Answers

I've had this happen before with car stereo's uh i just normally unscrew the screws out of the top of the player to where you can get to the tray or slot for the cds and force the cd tray or the cd itself out but be careful and not break the cd this might work it usually does for me

JBL MCDC100... | Answered on Dec 29, 2015

0 Answers

Error 3 when trying to use cd player 2001 toyota

Was the battery terminal taken off?

JBL MCDC100... | Answered on Jan 03, 2013

1 Answer

Changer sends out all disc and says bad disc

try blowing it all out with a air gun there may be some dirt on the inside. you may also want to try a cd cleaner

JBL MCDC100... | Answered on Apr 10, 2012

0 Answers

JBL 6 disc changer in

JBL MCDC100... | Posted on Aug 11, 2011 | Be the first to answer

1 Answer

Error 3 on my 6

try disconnecting power to the radio for an hour or so. usually it is best to disconnect the battery overnight to reset the microprocessors.

JBL MCDC100... | Answered on Feb 28, 2011

1 Answer

1996 ford explorer with JBL sound system with 6 CD

Welcome to Fixya

Try to use cd cleaner first to clean the lens. Its giving you a BAD CD error because the lens cannot read the disc. Do the cleaning method 2 times.

Please reply to this email for any update.

Thank yuo for using Fixya!

If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

JBL MCDC100... | Answered on Jan 03, 2011

4 Answers

Toyota 4 Runner 4 cd

as you said the cd is stuck and the tray is not comming outswitch off you system wait for few seconds then switch on the system and press eject take big needle or streighten the papper clip and you will find a small hole below the tray insert the needle and push it not hard burt hard the system tray will eject if still the tray is not comming out power off the system remove the cover by removing the screw after removing the screw u can see the cd remove the plug them and see if the cd tray comes out on not

JBL MCDC100... | Answered on Nov 08, 2010

0 Answers

I have a 6-disc JBL

JBL MCDC100... | Posted on Oct 25, 2010 | Be the first to answer

0 Answers

How do i fix the

JBL MCDC100... | Posted on Oct 12, 2010 | Be the first to answer

0 Answers

My 6-CD changer in a 2000 Avalon XLS began to show

JBL MCDC100... | Posted on Aug 28, 2010 | Be the first to answer

1 Answer

I have 6 CD Changer in a 2002 SLK 320 with changer

Have you tried putting the CDs in label-side down? My Alpine needs them to be label-side-up, but a friends changer (kenwood? I don't remember) needs them to be label-side-down.

Whichever way you've put them, try flipping the CDs to see if it makes a difference.

JBL MCDC100... | Answered on Feb 09, 2010

1 Answer

Tape player stopped working- spits out tape

I have the same problem. Any luck?

JBL MCDC100... | Answered on Jan 04, 2010

0 Answers

Error 3 on a Avalon jbl stereo

JBL MCDC100... | Posted on Oct 04, 2009 | Be the first to answer

1 Answer

2007 Toyota Camry Hybrid CD changer jammed, one

Take it to any local car audio shop, find out the make of the changer and chances are good that it can be fixed quickly and at a minimal cost or replaced with an aftermarket unit that will work perfectly with the factory radio for under 600 installed easily. Hope this helps

JBL MCDC100... | Answered on Oct 04, 2009

1 Answer

2002 Landcrusier 6 CD changer - CD's all skip at some point.

HI.. CD CLEANERS DONT WORK....IF YOU HAVE THE TIME.. REMOVE THE WHOLE UNIT OUT..AND CLEAN THE LASER...(Q-TIP,CLEANER)IF YOU THINK IT MAY JUST BE A DIRTY LASER IT'S SOMETHING TO TRY.. BEFORE GETTING A NEW ONE ..WITH OUT LOOKING AT IT IS HARD TO SAY.. CHECK ALL CONNECTIONS ALSO.. GOOD LUCK

JBL MCDC100... | Answered on Feb 21, 2009

1 Answer