20 Most Recent
JBL PB12 Subwoofer - Page 8 Questions & Answers
Explain connections - harmon kardon 130 to 4 jbl satellite speakers one middle speaker and seperate jbl subwoofer 140/230
Hello Ranasinghe, you must connect a JBL satellite for each Main L and R output (2 speakers in total)
Connect one JBL for each Surround L and R output (2 speakers in total)
The middle speaker, to the output of the Central channel and the subwoofer, if active or powered, to the RCA subwoofer output on the amplifier
This way you would have all the speakers connected in the Harman Kardon 130
Hola Ranasinghe, debes conectar un JBL sat?lite por cada salida Main L y R ( 2 parlantes en total)
Conectar un JBL por cada salida Surround L y R ( 2 parlantes en total)
El parlante medio, a la salida del canal Central y el subwoofer, si es activo o potenciado, a la salida RCA de subwoofer en el amplificador
De esta manera tendr?as conectados todos los parlantes en el Harman Kardon 130
4/15/2019 10:26:20 PM •
JBL Audio...
•
Answered
on Apr 15, 2019
Why did the right side stop working?
I have the same set and mine broke on me too. Though mine was the left side. It looks like you've opened up the back piece but you can get to the meat of it if you just push on the pole that ear piece sits under push back on it(don't snap) and use a little upward force on the ear piece. Then you can see where the wire has most likely disconnected. If it hasn't on that side you can do the same on the other side, it most likely has disconnected from the PCB as the wires are very very thin(what happened to mine). Just use a soldering iron and heat up the solder on the pad and put the wire back on. You need to make sure that the wire is exposed from the insulation first(I could use my nail to pull it off but the right wires looked different). I attached a picture I took with the PCB exposed. On the left and right you can see the two grey prongs you need to put some pressure on to remove the rocker and get in. On the PCB at the top left you can see the 4 pads the speaker wires connect to. My left speaker was disconnect so you won't see wires on there(red and black). right beside it is the right speaker connection(blue and white wires). those should be attached like in the picture.Use a soldering iron only if you have experience or with someone who does. I don't take responsibility for burns or fires or any other crazy mishaps. Doing this could break your headphones further, by burning the PCB or snapping the rockers on the side or any number of other things that could go wrong. So only do this if you already don't care if they break further.
4/9/2019 3:27:24 PM •
JBL Audio...
•
Answered
on Apr 09, 2019
Not finding what you are looking for?