20 Most Recent Kicker 02S10L74 Car Subwoofer Questions & Answers

0answers
0helpful
1answer

Sub static at low volume fine at high volume

Prob always there just can't hear it at higher volumes. Check the grounds of the amps an the Caps if you have them. Then check the preamp wires from the head unti to the amp. Keep it as shielded from power wires as you can. Some times tying a ground from the amp back to the head unit ground can fix a hiss or static
2/20/2015 9:23:26 AM • Kicker 02S10L74... • Answered on Feb 20, 2015
0answers
0helpful
1answer

My kicker l7 shows nothing wrong with it but wont work all of a sudden. whats wrong with it/

Faulty speaker wire. Dry joint in amp. Take speaker out & play with + & - wires on actual speaker to see if bad conection before cone
9/22/2012 12:38:43 PM • Kicker 02S10L74... • Answered on Sep 22, 2012
0helpful
3answers

I have a kicker l7 12 and it plays sound but its

kicker gives you a credit if u ship it back to them and upgrade. i have blown several old l7s the new ones are way beter. upgrade i did and am alot happier. the 02 l7s lasted a few months the 08s still going strong with a bigger box and its been 1 1/2 years and no problems. and yes your sub is blown......
8/11/2010 1:14:45 AM • Kicker 02S10L74... • Answered on Aug 11, 2010
0helpful
1answer

No bass

Your amp may bet set to "HPF" which is a high pass filter. It needs to be set to LPF
4/14/2010 5:45:38 AM • Kicker 02S10L74... • Answered on Apr 14, 2010
0helpful
1answer

Where can i send my l7 to have it fixed or is

you can send it back to kicker . What they are gonna do though if it isn't a current model is have you pay for a new model . You will need to call them first to get a repair charge / replacement charge and get an ra # . here is the address and phone number
Shipping Address
Stillwater Designs
3100 N Husband
Stillwater, OK 74075

Phone(405) 624-8510

7/13/2009 8:40:26 PM • Kicker 02S10L74... • Answered on Jul 13, 2009
0helpful
2answers

Voice coils

Hello. I do speaker reconing and amp rebuilds for a living and the L7's often suffer from tinsel leed wire breakage which can cause "poping" and "screaching" noises in the sub in various cone positions. You need to remove the sub and push straight down on the cone repeatly and determine if you can feel or hear crunching noises to make sure the voice coil and/or spider are not damaged. A faulty leed wire can usually be identified by a dark spot or obvious breakage. All of the L5 and L7 models can be successfully repaired as long as they are the older models that have a center cap in the cone. The newer capless models will have to have an upper brace cap glued to all of the cone's fingers and will have a rather ugly appearance. Leed wire overhauls usually run around $30.00 for the older models. Voice coil and spider overhauls run around $90.00.
2/24/2009 1:42:29 AM • Kicker 02S10L74... • Answered on Feb 24, 2009
0helpful
1answer

Wiring my 2 L7 with a kicker 1000times1

Run the subs in series then bridge the amp. So run the normal + to - to the one sub then hook up a spare wire (not connected to the amp) to the same + and - connections. Then run the spare wire to the + and - of the other sub. This will tie the 2 together so you can bridge the ampfor more power instead of using 2 seperate channels.
2/6/2009 12:21:10 AM • Kicker 02S10L74... • Answered on Feb 06, 2009
0helpful
1answer

Subwoofer works at high volume, doesnt work at low volume

You had the settings set incorrectly and overdrove it. The voice coil leads are burn't open. If you look at the little flexible braids by the terminals I'll bet they are black/brown and maybe even burn't in half. It's toast.
1/27/2009 3:21:38 AM • Kicker 02S10L74... • Answered on Jan 27, 2009
0helpful
3answers

Only subwoofer works at high volumes

It could be your receiver but you can try seeing if the Woofer has a input knob at the back, maybe this down, or maybe.if possible turn down the amount going to the woofer with your receiver.
12/28/2007 5:39:37 PM • Kicker 02S10L74... • Answered on Dec 28, 2007
0helpful
1answer

Wiring woofers

Well, you have the 4 ohm dvc kickers, and your amp being stable to 2 ohms doesn't go together very well. If you wire the voice coils in series, and hook the speakers to the amp in parallel, you get 4 ohms, which doesn't use all the power your amp is capable of. If you run the voice coils and the speakers in parallel, you'll drop the resistance to 1 ohm, and probably fry the amp, or at least deal with overheating issues. Better be safe than sorry. You need to run each speaker in series, which means running a positive and negative to each speaker, and a jumper from those terminals to the opposite colored terminals on the second voice coil. Diagram can be seen here: http://www.kicker.com/06/tech-support/manuals/manuals/02SoloBaricL7manual.pdf That puts two 4ohm voice coils in series, and raises the resistance of each speaker to 8 ohms. Then, you have to run both speakers in parallel to the amp. When you run two 8 ohm circuits in parallel, the total resistance of the circuit is 4 ohms. That means seperate positive and negative wires to each speaker. If it is a mono amp, connect both negatives to the negative output, both positives to the positive output. If it is a multi-channel bridgeable amp, You'll probably connect the negatives to one side output (right for example) then connect the positives to the opposite side output (left for example). If you need to bridge your amp, make sure it is bridgeable, and also that you have the speakers bridged to the proper amp outputs. If not sure, reply back here with the amp model number, and maybe I can help you further.Thanks, and I hope this solves your problem.
11/29/2007 9:20:29 AM • Kicker 02S10L74... • Answered on Nov 29, 2007
0helpful
1answer

The wire spilt in side the voice coill

take off the outer ring then take a razor to the under part of the rim . carefully cut the sillacone glue from the metal rim .After that remove the coil fin the same way . find the wire and take really thin solder wire and use a very small amount to repair
11/3/2007 10:39:29 PM • Kicker 02S10L74... • Answered on Nov 03, 2007
0helpful
2answers

DHD NTX-3107 Wont turn on anymore.

Hi, Please check that you've swapped out any associated batteries of your amplifier. And also, please double check that you're using compatible fuses as some manufacturers build their machine to only work with their own products like fuses. If all of these things fail, you might need to reach out to the manufacturer of the product if you don't have access to the manual for troubleshooting. Thank you.
10/21/2022 12:49:35 AM • Kicker Car Audio... • Answered on Oct 21, 2022
0helpful
1answer

Kicker CXA 400.1 ...accidentally hooked up + and - backwards now just keeps blowing inline fuse immediately. How can i fix this? Inside amp nothing looks damaged

Send it back to maker for repair.

CX400.1 Mono Amplifier - KICKER

https://www.kicker.com > CXA4001-400-Watt-Mono-C... Using efficient Class-D power, the CXA400.1 features a variable bass boost with KickEQâ„¢, giving you as much as a 6dB of extra bump with a simple turn of the ..
10/9/2022 7:12:08 PM • Kicker Car Audio... • Answered on Oct 09, 2022
Not finding what you are looking for?
Kicker 02S10L74 Car Subwoofer Logo

16 questions posted

Ask a Question

Usually answered in minutes!

Top Kicker Car Audio & Video Experts

Morne Olivier
Morne Olivier

Level 2 Expert

265 Answers

Marvin
Marvin

Level 3 Expert

85241 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1192 Answers

Are you a Kicker Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kicker Car Audio & Video

  • Kicker Car Audio & Video

Most Popular Question

kicker l7 12 plays sound but its

  • Car Audio & Video
Loading...