20 Most Recent Saniflo Saniplus Macerating Pump - Page 7 Questions & Answers


The cartridges, yes, sounds like they are nearing their end. As they do shut off, I see no problem in letting them go for awhile; but eventually they will reach a point where they will drip (not shut off completely). Personally I prefer OEM cartridges, not aftermarket.

Plumbing | Answered on Jun 19, 2019


The first thing that comes to mind is the shut-off valve under the sink (on the hot water side) may not be open all the way.

The second is that there may be dirt/debris in left in the hot side.

The third concern may be that the hot water may be restricted before it gets to the faucet. (Blockage, corrosion, kinks, etc.)

Plumbing | Answered on Jun 19, 2019


Good morning! please try to uninstall the water filter, then observe if there's water flowing on the tube, if there's water flowing then it might be the shutoff control valve that is defective which mean that we have to replace it. best regards

Plumbing | Answered on Jun 19, 2019


If the AC POWER LED is flashing, it indicates "excessive battery drain". According to the manual, the fix is to "stop the pump" and "allow the battery to charge." If BOTH the AC power LED AND the CHARGING MODE are flashing, it indicates that the unit failed pre-qualification test #1. The fix is to replace the battery. That would be my guess as well, the battery needs replacing. BTW, I wasn't able to find a manual for the A-5500, but I did find a manual for the A-5200. Different controller, but same LED indicators scheme and probably same under the skin. Here: https://www.pentair.com/content/dam/extranet/flow/manuals/simer/a5200-manual.pdf

Plumbing | Answered on Jun 17, 2019


Possibly foot valve stuck open. As it leaks down, pressure switch calls for pump. Foot valve leaking will cause loss of prime.

Plumbing | Answered on Jun 17, 2019


I found this site and thought it might help you with your problem;
https://www.levcocare.com/2013/01/10/frost-proof-faucets-wk-2-2013

Plumbing | Answered on Jun 09, 2019


Usually it can be remove by hands buy twisting. If it's too tight then have to use wrench.

Good luck


Mai

Plumbing | Answered on May 28, 2019


Take it for repair, this toilet is controlled electrically and need to be adjusted or repaired. This is something you not want to repair.

Plumbing | Answered on May 26, 2019


Remember correctly there should be a clip that you take out and there is a tool that you can use to pull the stem out to knows I'll just slide out but other times you may need the special tool you can pick up like at Home Depot or any hardware store

Plumbing | Answered on May 20, 2019


Sounds like air in the line. bleed it at the wall supply line.

Have a rag handy and loosen the line till it sputters then open(turn on) faucet. turn off and tighten line.

Mike

Plumbing | Answered on May 19, 2019

Not finding what you are looking for?
Saniflo Saniplus Macerating Pump Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Saniflo Plumbing Experts

Bill Johnson

Level 2 Expert

306 Answers

Vernon Taylor

Level 3 Expert

7426 Answers

Tom Chichester

Level 3 Expert

61123 Answers

Are you a Saniflo Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Saniflo Plumbing

  • Saniflo Plumbing

Most Popular Question

get lid over rubber older saniplus seal

  • Plumbing
Loading...