Lanzar Vibe 1200D Car Audio Amplifier - Answered Questions & Fixed issues

You will need to show it to a service technician as it seems the output section has blown so it remains in protect mode. One reason (could be) that the input to the amp was high and may have been clipping for some time before the amp decided it could take it no more

make sure your ground is drilled threw thick metal and the paint is scraped off and make sure that all the wires connecting the amp are 4 gauge or higher and if that doesn't do the trick get a better amp that can throw more power

connect the red wire of the amp to a car battery (+). the black to a car metal and the remote cable to the blue wire in radio. when you turn on the radio the amp turn of--when you turn off the radio the amp turn off.

overheating. may not have enough power supply. install capacitor

Depends on if your using it for a sub,or in inside.i can help you hook it up give me some specs on your equipment.and what your using it for.

Depends entirely on the output impedance of the amplifier and of course if it matches your loudspeakers.

Your 8ohm channel is fried why happened was you ran 2 12s in an 8ohm load and turned it down to 2ohms the speakers was pulling all the power and that made it over heat and when it over heated it fried you're amp. It ain't no good you can't fix that

Bad connection inside either on a connection or on the PCB itself.

When an amplifier causes trouble or otherwise stops working, it is necessary to eliminate external possibilities such as a short circuited output. If nothing external is causing the problem, unless you have a good friend who is an electronics engineer, it will be a repair shop task...

Check your fuses. Check to see if any of the wires are loose. Could be a blown fuse or loose wire. Possibly the following link might be of interest: https://www.youtube.com/watch?v=xMbsieEj0UM

https://youtu.be/1icfF0r30ls

Into what?

have diagram of any sort?

What is a Lanzar P124D?

Please clarify your question on whatever this product is.

Contact t lanzar for a replacement harness.

Because it's drawing more power than the fuse can handle get a fuse with a higher rating. A 100 app fuse worked great for main power with my setup 760w amp a 15"sub 2 10"subs and a 12" sub. Also my amp had 2 30amp fuses on it one for each channel but I ran everything out of one channel.

Is the amp 2 or 4 channel?

You need to find out the voice coil ohms and if you have 1 or 2 voice coils in each sub and then wire accordingly.

Contact where you purchased them from. If they blew with in that short of time it may be user error not hooked up correctly ,wrong impedance, gain to hi on the amp didnt break them in . this will all void any warranty.. .