20 Most Recent Ariston Technologies AWD120 13 lb. Washer / Dryer Combo - Page 6 Questions & Answers

It means "heater relay cannot be activated". Troubleshooting guide says to tap the relays to try to unjam them. If that fails, replacement of the main control board is necessary. These washers apparently have a propensity for stuck relays on the newer units.

water h2o is symbel for water

bearings gone

inner and outer drum has to b removed replace the bearing kit 2 bearings one oil seal as kit

should b some slack on motor loosen bolt with elonggated slot

could b depends on how often used

e spares

Most common causes of noisy spin are something has found its way between the drum and its casing or the heater has come adrift from its fixing and is rubbing on the drum

maybe a under wire from bras stuck in drum.when machine is empty look in drum holes and see if anything is poking through the holes.keeping turning the drum as you look,sometimes hard too spot has the tips are often white.

h2o is the chemical symbol for water. But if the water keeps running and does not stop, even when the machine is full it could be the machine has a defect level indicator, or the water lock does not work. When the lock even don't closes what you remove the power the lock is defect.

call a repair tech? Fix it? What is the question?

HI Mostafa. Try this link.

Search: Aml85 - view online ' e-Manual.eu

Good Luck Nomess

There is no fuse in the machine. The fuse is in the electrical panel of your home. If there is power in the outlet then the fuse is not tripped. If there is no power reset the circuit breaker or (very old) replace the fuse. Here is the link to the manual for the machine. http://www.aristonappliances.us/_pdf/manuals/ASL75_CXS_MANUAL.pdf

Either the knob or the switch is faulty. Can you pull the knob off and see if you can set the program with pliers on the shaft?

F13. NTC (Dryer Temp) Open / Short Check wiring continuity to Control Board. Replace NTC. Or, replace Control Board NTC is the temperature sensor

sounds like the pump could be unable to get the water out after the wash. check the door into the pump, at the bottom front of your machine