20 Most Recent Viper Security and Remote Start System (basic install included) - Page 5 Questions & Answers

0helpful
2answers

Viper 5901 Starting issues

i need to adjust the time that it waits to start for my glow plugs in my 2001 ford excursion diesel 7.3. I need it to wait another 10 - 12 sec.
1/23/2010 7:28:12 AM • Viper Security... • Answered on Jan 23, 2010
0helpful
2answers

My Viper 791XV will not remote start my 2005 F150

I have the same problem with my, the keydrop program is not there anymore. it has to be reprogrammed. I have a Ford Expedition and was told that fords drop the programs sometimes.
1/18/2010 1:47:32 AM • Viper Security... • Answered on Jan 18, 2010
0helpful
1answer

I have the viper 791vx

Sounds like a bad door pin switch or the wiring to the pinswitch.
You'll have to verify all door pinswitches and the hood pin switch.

Thanks

1/13/2010 1:52:58 PM • Viper Security... • Answered on Jan 13, 2010
0helpful
1answer

Viper 5601

That is all you need , just follow wiring schematics and programing steps . Good luck
1/12/2010 1:56:51 AM • Viper Security... • Answered on Jan 12, 2010
0helpful
1answer

My problem is i have

did you bypass the factory security system?, because without the transponeder key in the ignition the engine control computer and the anti-theft module will lock u out, no fuel to the engine, on a GM you bypass the VATS system with an aftermarket module, there should be a kit or module you can buy to do this on a Ford, you will need to contact the remote start support techs for the info on this and where to buy it an how to install it.
1/11/2010 3:55:02 AM • Viper Security... • Answered on Jan 11, 2010
0helpful
1answer

I put a new battery in my Expidition and now my

put your key in the ignition leave it in the off position, now remote the truck, if it starts you need to have the transponder loop adjusted
1/9/2010 3:46:34 PM • Viper Security... • Answered on Jan 09, 2010
0helpful
3answers

Were can i find an istallation guide for a viper 7900

Forget the greedy ebayers, go here for the guide
12/31/2009 8:40:49 PM • Viper Security... • Answered on Dec 31, 2009
0helpful
1answer

I need the wiring schematic for a 2002 pontiac

go to the autozone website. and register for tech tips....all is free and should have all you need
12/31/2009 12:14:38 PM • Viper Security... • Answered on Dec 31, 2009
0helpful
1answer

After 4 years of being turned off, it started screwing up again.

if your worried about it not being installed correctly you should take it to a shop in your area and have it professionally removed or properly installed. if it is a remote start system i wouldn't tackle it yourself. most alarm systems tie into the starter and or ignition circuits. if you want a quick fix look under neath the dash for a small black box with a bunch of colorful wires going to it. there will be a few plugs, one with 10 or more 20 gauge wires. this should be the power input along with light flash door trigger hood trigger etc etc. try unplugging it, the led light should stop and it should give you no more trouble. after doing this make sure you check that the vehicle still starts. if you have any other questions or are located in the Phoenix, Arizona area i would be more then happy to help.
12/29/2009 4:32:28 AM • Viper Security... • Answered on Dec 29, 2009
0helpful
2answers

Hello, i have an old

Something in the circuitry has gone wrong if you're lights flash. The alarm is getting the signal to activate and disarm except the remote doesn't give the signal to make the horn alarm chirp once's for on and twice to disarm. The exact same problem occurred with my service van alarm, a viper. It works fine but I have to go by the flashes or look at the red led light to make sure it is on.I just live with it as long as it works. I have tried everything to repair it with no luck. Please let me know if you figure it out,lol. I hope you'res will work again. Sincerely,
Shastalaker7
12/23/2009 4:49:28 PM • Viper Security... • Answered on Dec 23, 2009
0helpful
3answers

Car is NOT starting. Lights are not

is the car starting using the key? (manually), if so, then replace the remote battery, if problem still persists, then check the remote & the car's receiver...
or
the car's battery or some controller might be out-of-service!
new cars are electronically controlled, if any problem occurs, it jams the whole car,  perhaps this might be your case.. For your Safety: it is recommended to ask help from Honda Service Centre!!
12/13/2009 10:05:17 PM • Viper Security... • Answered on Dec 13, 2009
0helpful
3answers

Viper works but remote start and keyless entry does not

On the remote start part, it might be as simple as relearning the tach. To do this, crank the car with the key, press and hold the valet switch until the led lights and stays solid now release.Try the remote start. Need to know what kind of car to comment on doorlocks.
12/10/2009 2:32:33 PM • Viper Security... • Answered on Dec 10, 2009
0helpful
1answer

2003 Buick Century Remote Starter wiring Info.

have istallation guide for a 7900 viper
12/5/2009 7:30:48 PM • Viper Security... • Answered on Dec 05, 2009
0helpful
1answer

Remote no longer unlocks doors (550ESP).

Check the battery from the remote.
12/4/2009 9:53:54 PM • Viper Security... • Answered on Dec 04, 2009
0helpful
1answer

Battery went dead on vehicle

Make sure the battery was not put in with the cables on wrong.Then look,and make sure there was no other wires left off the battery,or unplugged.When the battery was put on,did the battery cable ends get cleaned?If you are not sure,remove them and re-clean them,they should be shiny,no grey,or black film on the contact area,this acts as a insulator,and the starter can not get enough amps from the battery.If none of this works.Get in the car and turn the key on,for 3 minutes,and let the computer learn,and reset.Then turn the key off,for about 30 seconds,and try to start it.If it does not start,the dealer will have to re flash the e c m,to get you going,removal on most new model cars,without a12 volt supply hook up in the aux plug in the car,will cause the car to loose memory.And if the battery looses voltage,to the car,it will also.I hope all this helps you,and if it is at all helpful,please let us know,thank you.
11/16/2009 1:57:01 AM • Viper Security... • Answered on Nov 16, 2009
Not finding what you are looking for?
Viper Security and Remote Start System (basic install included) Logo

Popular Tags

204 questions posted

Ask a Question

Usually answered in minutes!

Top Viper Home Security Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

popy Pafy
popy Pafy

Level 1 Expert

69 Answers

Are you a Viper Home Security Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Viper Home Security

  • Viper Home Security

Most Popular Question

when starting cold starts stalls

  • Home Security
Loading...