20 Most Recent GE 30" Built-In Single Electric Wall Oven - Bisque-on-Bisque - Page 8 Questions & Answers

F2 means it thinks the oven temperature is over 900 degrees with the door locked. You can try to cycle the power to the oven to clear the code. If that doesn't work then it could be the temperate sensor, or the relays bad or shorted out. Here is a amazon link for a relay that should look similar to what you have depending on your model #. Amazon com GE WB18T10352 Relay Home Improvement

Hello, You should replace the door lock mechanism and the door switch. Global Solutions Appliance Repair https://gsappliancerepairnyc.com/

First, I'm not a GE tech. * Check your warranty. Call for service. *** The following is for information only *** * GE Self Cleaning Oven instructions (a bit fuzzy); https://www.youtube.com/watch?v=2_hO7R29E9Y * Updated video (steam clean version); https://www.youtube.com/watch?v=yg3EBU99PSE * Older models (my mom's stove 1970's); https://www.youtube.com/watch?v=uBQa_yIyfgI * Be safe contact GE for specific questions.; http://www.geappliances.com/ Aloha, ukeboy57

Unfortunately, the F91 error indicates that the door lock is not functioning or the signal that the door is locked didn't get to the control unit. The range will not begin the self-clean cycle if there is a chance that you could open the oven door when the oven is dangerously hot. First try cycling the power by unplugging the range (or turning off the circuit breaker). Next check if the lock has engaged. If the lock doesn't engage, check if the mechanism is bent or binding. Next check the wiring to see there is damage that will prevent the communication between the control board or the door lock. Check for corrosion at the wiring harness connections. If the error happened after doing a self-clean, I'd suspect the door lock hadn't released. That can be related to a damaged over-temperature sensor or the lock itself. If the range has been self-cleaned before, it's possible that the lock was broken after forcing the door to open after that self-clean cycle. You may need to replace the lock, the wiring or the control board. Please add a comment with the model of your range for a parts diagram. If your range is under warranty, contact GE. I hope this helps. Cindy Wells

Yes the lock must be disengaged. If you cleaned it the lock will stay locked until the oven cools down to a safe temperature.

The main control board for the oven is fried.

sounds like a faulty thermostat

Push the clock button until the colon between the hours and minutes starts to flash. Use the up and down arrow buttons to set the time then push the clock button once again to make the colon symbol go solid.

f3 is a shorted sensor and f5 is a bad computer board or clock assy. same thing http://www.appliancehelponline.com/generalelectric.html

Usually, This means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be canceled, replace the oven control (also called clock or ERC), touch pad, or both.

Does this stove have fuses . if so one or more could be burnt out.