20 Most Recent Hotpoint 30" Self-Cleaning Freestanding Gas Range - Black - Page 7 Questions & Answers

You can get a steel wire brush and clean the area if your oven pilot is an open flame and not electronic. As far as adjusting its not recommended, not to mention not safe, to modify anything pertaining to gas. If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

you may have your gass set to low or you need a new regulator valve

You definiatly have gas leak. The only way to find the gas leak is either use a gas leak detector which is an expensive device to buy and the second method is to use your eyes, nouse and a sponge with soap on it and every posible joint that is suspect put the foam over the pipe joint to see if you have any small bables created. Where you see small babbles then you have the leak .

Hi, I have the same (old) model : KE638JW-1 and type B40 (not 340) Fuses are in the top and when you are in front, from your left to your right , this is the order : 30A 20A 20A 15A 30A 20A 20A All fuses appears twice (may be one for each phase): 30 : OVEN 20 : LEFT (2) RING HEATER (may not be the right word) 20 : RIGHT (2) RING HEATER 15 : LIGHTS and 110V plug 30 : OVEN 20 : LEFT (2) RING HEATER 20 : RIGHT (2) RING HEATER If you are interested, I can take a photo of the instruction normally sticked in the header. Just write to me at : C O M S P A M@V I D E O T R O N.C A and since it is an antispam address, be sure to put (copy) this in the subject : FIXYA - KE638JW-1 PHOTO hth ps : I know it may be to late, but I put the answer for anyone which come here. Bye Sebastien