Top 20 Dacor ECS127 Epicure Electric Single Oven Questions & Answers

0helpful
1answer

Singal wall oven is out/ the electrical is out

Check fuse box or circuit breaker (MCB).
12/21/2013 12:30:04 AM • Dacor ECS127... • 54 views • 0 helpful votes
0helpful
1answer

Oven does not heat up there is power to unit. oven

Hi,If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.Oven Problems Electric Oven is Heating Slowly or Poorlyheatman101
9/25/2011 2:46:02 PM • Dacor ECS127... • 232 views • 0 helpful votes
0helpful
1answer

Broiler element not heating

Hi,
If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101
3/11/2011 10:18:19 PM • Dacor ECS127... • 194 views • 0 helpful votes
0helpful
1answer

What does the F1 mean

Hi, the F1 error code means a problem with the System Watchdog Circuit..

Press "Cancel", if beeping continues after 30 seconds, replace the main control board (also called clock or ERC).
11/16/2010 11:34:40 PM • Dacor ECS127... • 492 views • 1 helpful votes
0helpful
1answer

What does "PRB 400 (degrees)"

Hi,

PRB stands for Power relay board.

This is a bad error. This means that the power supply board had failed and needs replacement. The cost of replacement would be anywhere between $150 to $300.Unfortunately, this is not a DIY. You need to call a tech on site to replace the same.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
11/25/2010 9:52:35 PM • Dacor ECS127... • 132 views • 0 helpful votes
0helpful
1answer

Heating element won't heat. Checked breaker,

Hi,

It gets tricky from there...

I would check for power at the element....if there is power and the element is not getting hot then you have a bad element.... 220 volts across the two wires to the element or more is considered proper power...

If there is no power there.... then you need to flow the wires back till you get power and that is where your problem is....

This is the best way to troubleshoot your oven...but a good quality electrical meter is needed.... and you need to be very careful when working with electric as it can kill you!!!

heatman101
11/6/2010 11:50:57 PM • Dacor ECS127... • 77 views • 0 helpful votes
0helpful
1answer

Oven will not heat

Hi,


Check out this tip that I wrote about this problem...

http://www.fixya.com/support/r4511800-oven_problems_electric_oven_heating

heatman101
4/23/2010 11:20:22 PM • Dacor ECS127... • 147 views • 0 helpful votes
0helpful
1answer

I cleaned my oven and now the elements will not

There are several possible causes of this failure. Here is an article that addresses them, although written for a GE oven it may be also be relevant to your machine:

www.fixyourboard.com/techzone/ovens/f1_error/f1_error.html

Maybe this will shed some light...

Best Regards,
Bruce
www.fixyourboard.com
3/3/2010 3:32:46 AM • Dacor ECS127... • 116 views • 0 helpful votes
0helpful
1answer

DACOR E0224SCH HAS L-50 FAULT CODE

Here is a complete DACOR technical manual, this should help you figure out why the latching mechanism is not operating correctly. Take a look at page 24 this has some information on your situation.

http://www.scribd.com/doc/14008662/Dacor-Technical-Manual
1/26/2010 8:45:34 PM • Dacor ECS127... • 255 views • 0 helpful votes
0helpful
1answer

I don't know how to clean the oven

You should have a function switch that says " self clean ". Normally, all you have to do is turn the control on to "self clean" and let the oven do the rest. It will take about 3 hours or so to complete the cycle.
1/30/2009 9:55:22 PM • Dacor ECS127... • 284 views • 1 helpful votes
0helpful
2answers

Dacor error codes

HI. the F-1 code is a System Watchdog Circuit failure code.

Press "Cancel", if beeping continues after 30 seconds, replace the main control board (also called clock or ERC).

Concerning the F-5 code. This is an oven temp sensor failure code. have it replaced asap. ((Check the wiring leading to and from the control and sensor for cracks and fouled structure. if the wiring is bad, replace the harness as well)),
4/25/2008 3:58:48 AM • Dacor ECS127... • 3,351 views • 4 helpful votes
0helpful
1answer

Oven not heating

i have had this problem twice. once was the heating element actually had shorted out because the little ceramic holders had broken, this necessitated getting new element. can be checked out with an ohmmeter by yourself or by taking element into appliance repair place. the other time, it was that the manual reset switch had tripped after a self-clean cycle. actually at the moment, that has happened again- design flaw perhaps in the RSD30 range?
so anyone who can tell a reasonable competent refrigeration/HVAC technician where the manual reset switch is would be appreciated.
10/28/2007 2:00:14 AM • Dacor ECS127... • 403 views • 2 helpful votes
0helpful
1answer

Dacor Oven. DTOV127. My bottom oven is working fine. Top oven- After an electrical outage, the door is locked, can't open and is flashing the locked sign and rattling terribly. What do I do?

Hi, you might want to shut the power down to the unit and then call Dacor directly to help you troubleshoot the issue. Their phone number is 1 (833) 353-5483. Thank you.
10/3/2022 12:29:37 PM • Dacor Ovens • 31 views • 0 helpful votes
0helpful
1answer

Dacor MORD203S; lower oven broil burner is coming on regardless of setting

You have a failed control, or valve. turn off the gas feed immediately. The fix is to replace the control or valve. Be sure you have the skill set if you are attempting to replace the control or valve yourself. A mistake could seriously hurt or kill you.
9/28/2021 3:53:18 PM • Dacor Ovens • 91 views • 0 helpful votes
0helpful
1answer

Do i really need the cooling fan to work if i have bypassed the u60 code on Dacor oven

It obviously is requesting you to replace the fan and or the relay. If it comes with the oven it is definitely needed.. Bypassing anything could cause a fire and you would lose your home. I wouldn't bypass it. Please have it repaired correctly by an authorized repairman.
5/10/2021 10:49:52 PM • Dacor Ovens • 223 views • 0 helpful votes
0helpful
1answer

Dacor electric cookstop won't lock.

?????? ????? ????
3/22/2021 7:20:35 PM • Dacor Ovens • 37 views • 0 helpful votes
Not finding what you are looking for?
Dacor ECS127 Epicure Electric Single Oven Logo

Popular Tags

36 questions posted

Ask a Question

Usually answered in minutes!

Top Dacor Ovens Experts

Jaime Hernandez

Level 3 Expert

2351 Answers

Paul Bade

Level 3 Expert

1717 Answers

Ngoro

Level 3 Expert

3508 Answers

Are you a Dacor Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dacor Ovens

  • Dacor Ovens

Most Popular Question

f1 mean

  • Ovens
Loading...