20 Most Recent Dacor Epicure ERD36 Dual Fuel (Electric and Gas) Kitchen Range Questions & Answers


Have you checked the oven fuse, there should be one on the stove. To check the element power, remove the element from the back where its attached to the stove Remove the element from the wires (Skip this step if you are absolutely sure the element is not working). Attach your meter clips to the 2 wires (meter set set to at least 250Vac), place a piece of cardboard under the screws and meter clips to isolate them from touching any metal parts of the oven. Turn the meter on, set the oven thermostat to 350, you should have at least 220Vac, if you do the power is fine. Test element for continuity, and for a possible short.

Dacor Epicure... | Answered on Mar 01, 2015


most likely the relay board. it's a common problem with this range. most repairs are just replacing the relay board (~ $225 part). getting to the relay board isn't easy, by doable by removing the burners, top plate (special tool for burner rings), insulation, another plate(s) with a lot of screws, right two burner lines, then another small access plate. make sure to mark where the wires go, and of course power off. either a relay goes out or a solider joint pops loose. if you have time, i'll would remove the board and inspect the joints (look for the relay with the wire marked "ba"). its goes to the lower heating element. if you see a bad joint, then re-solider it and try the board. (this worked for me). if it looks good, then look for a burnt relay (or you can test it with 24v).

Dacor Epicure... | Answered on Jan 21, 2015


Place a hammer handle between the hinge and the door frame. Exert moderate pressure to close the door. It should spring back to normal position. Do both sides.

Dacor Epicure... | Answered on Aug 17, 2014


open door fully left and right hinges have a tab at the top of the hinge close to the range pull both down then close door to approx. 45 degrees till door won't close then pull strait up
Cheers

Dacor Epicure... | Answered on Dec 11, 2013


ok.. don't you any schematic manual in there...?

Dacor Epicure... | Answered on May 20, 2011


Are you getting any trouble codes on the control panel? If not then the elements may just be burned out. If you have a volt ohm meter, pull the elements out and check them for resistivity, or ohms, this should go to infinity if it is good and if they are bad then reading will be very low to nothing at all. If they are good, then check the element plugs for voltage, if your not getting any juice to the element then it must either be the thermostat, or the control panel. Let me know what you find.

Dacor Epicure... | Answered on Apr 09, 2011


Hi
It is either caused due to loose/broken wire on the oven temp sensor or the sensor is bad and should be replaced. To solve this issue start by checking the oven temp. sensor for 1100 ohms, if the rating is more then that then check the control and door switch and replace the part that is bad. Hope this helps...please post back for further assistance.
Daniel

Dacor Epicure... | Answered on Feb 28, 2011

Not finding what you are looking for?
Dacor Epicure ERD36 Dual Fuel (Electric and Gas) Kitchen Range Logo

82 questions posted

Ask a Question

Usually answered in minutes!

Top Dacor Kitchen Ranges Experts

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Paul Carew

Level 3 Expert

3484 Answers

Are you a Dacor Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dacor Kitchen Ranges

  • Dacor Kitchen Ranges

Most Popular Question

used self cleaning function next day

  • Kitchen Ranges
Loading...