20 Most Recent Frigidaire FAC084N7A Air Conditioner Questions & Answers

My little Frigidaire (5 or 6k btu) beeps intermittently and is really annoying. I never know whenn it's going to happen.

Frigidaire... | Answered on Jul 17, 2015

Good Morning Friend,

I understand you are looking for the manual to your Frigidaire air conditioner, model# FAC084N7A. I also see you want to know the BTU rating. Your air conditioner is rated 800-BTU. I have attached the manual below. Hope this is helpful.

-Best Regards-
Frigidaire Manual Search Results

Frigidaire... | Answered on Jul 11, 2014

If you have a unit that has stopped cooling in a couple of days... tkae it back and get another one...you got a lemon...
do not mess with it or tear it apart... just put it back in the box and return it for another one...


Frigidaire... | Answered on Aug 31, 2010

Clean floor of unit under coils so front coil water can drain under the coils to the back drain.
Don't forget to tilt them unit a bit to the back to allow the water to drain towards the back.

If this was helpful please rate me.
Leo Ponder Appliance-Tyler,Texas
[email protected]

Frigidaire... | Answered on Aug 23, 2010

It needs cleaning ,if it is a window unit,remove it from the window,from it`s shell,and take it out side and wash it out,be careful not to bend over the fins on the evaporator,and the condenser with the water hose.If this does not help,then it needs some freon.

Frigidaire... | Answered on May 31, 2010

It's obvious to me that your motor 'quit' turning because of a lack of lubrication.

You have one 'slight' chance here - and that depends on whether or not you are able to take a drill and 'drill' a small hole on top of the bearing case (which encases the bearing).

On most motors you can do this quite easily. Just look on the end of the motor (where the shaft comes out of the motor) and you should see the bearing encasement (on some motors this is internal and you won't be able to do this). - but in any case if you can - 'just drill a small hole at the top of the encasement and then take a oil bottle, one of those plastic ones with the long slender tube - and oil the motor. I've done this many times in the past and more times than not your fan motor will run normally for quite some time.

Note: you must understand though - that the damage already done to the motor 'might' cause this manuver to be un-sucessful, i.e. the motor may run and not make noise but will heat up and go off - or it may still make the grinding noise and also heat up and go off.

But, you do have a chance this way.

If this doesn't work - the only thing to do is to replace the motor.

Note: I've never took one of these motors apart and tried to oil the bearings as you suggested - mainly because the chance of success - versus the "time and trouble" to do so is very slim.

good luck!

Frigidaire... | Answered on May 16, 2010

There are a few checks that could be done, i.e. you could 'ohm the compressor out' to see if it had a 'short, or its windings are 'opened.'

Or - if there was a valve on the AC - you could tell if the system was holding it's refrigerant or not - you could also visually examine both coils to see if they were 'clean.'

But to 'make sure' the AC is operating 'correctly' will require all the components to be working - including the fan motor.

Frigidaire... | Answered on May 15, 2010

Does it get cold? You can try cleaning the fins-both inside and outside, with windex. Smoling & cooking will create a sticky deposit that will make dist that gets through the filter stick and it won't cool properly.
If it doesn.t get cold any more, try replacing the starting capacitor. About $5. If that doesn't take care of it, just replace the unit. They are cheap enough these days, that you can replace a unit with a more energy efficient unit for the same cost or less as a repair would cost.

Frigidaire... | Answered on May 26, 2009

Thank you for your post, John!

Based off the information you have provided you need the code for a universal air conditioner remote. You may need to speak with manufacturer of the remote for that direct code. Best of luck! -Matt

Frigidaire... | Answered on Jun 11, 2020

Make sure that the cooling coils are clean. Also that the cooling fans are working. It may have lost it's treon and it is time to buy a new one.

Frigidaire... | Answered on May 20, 2020

Press and hold the UP and DOWN Temperature Selection Buttons at the same time for 3 seconds.

Frigidaire... | Answered on Apr 16, 2020

It appears to have an electric heater core. See item #12 on the parts diagram

Frigidaire 12000 BTU AC & Heater Window Unit Heat Cool ...

https://www.ebay.com > ...

Find many great new & used options and get the best deals for Frigidaire 12000 BTU AC & Heater Window Unit Heat Cool FAZ12HR2A at the best online prices ... [PDF]


ftp.electrolux-na.com > prodinfo_pdf > edison

Jul 4, 2002 - M40L0004.eps FAZ12HR2A Parts.eps. 63611647.eps. Product No. FAZ12HR2A2. Series. Cool/Heat. Color white. Volts. 230/208. BTU-Cooling.

Frigidaire... | Answered on Nov 19, 2019

yes, but when it is running, does it also turn off??

Frigidaire... | Answered on Jul 26, 2019

Could have clipped the low voltage wire outside with a weed wacker, could have blown out the run capacitor or lost a major component! If the unit is buzzing when you turn it on but nothing's running (compressor or fan)then you have a failed run capacitor! The list of things it could be are endless without more info

Frigidaire... | Answered on Jul 13, 2019

Not finding what you are looking for?
Frigidaire FAC084N7A Air Conditioner Logo

11 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Heating & Cooling Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers


Level 2 Expert

111 Answers

Brad Brown

Level 3 Expert

18402 Answers

Are you a Frigidaire Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Frigidaire Heating & Cooling

  • Frigidaire Heating & Cooling

Most Popular Question

leak water in front air

  • Heating & Cooling