20 Most Recent Frigidaire FAH085N1T Air Conditioner - Page 8 Questions & Answers

Hello David Forgey, thanks for your post!

Based off the information you have provided the compressor within your Frigidaire air conditioner continues to run when turned off and in different settings. It could be an issue within your control panel or a problem within the wiring harness. I would perform a reset on your air conditioner by unplugging the power cord for ten minutes. If that does not correct the issue you may want to consult with professional technician for proper repairs. Hope this helps. -Matt

Thank you for your inquiry, Angela Babin!

From my understanding your Frigidaire air conditioner is displaying an error code "H5". Normally, the error code "H5" stands for heater thermistor error. I would recommend performing a reset on your air conditioner by unplugging it for ten minutes. If that does not help correct the error code it could be a possible problem with your thermistor or control board. I hope this is helpfully. -Matt

Hello friend, thank you for your post!

Based off the information you have provided your Frigidaire air conditioner, FAZ08HS1A, is not heating up or changing fan speeds. From what you are describing it sounds like a potential problem with the control board or sensor. I would suggest performing a reset on your air conditioner and you can do that by disconnecting power from it for ten minutes. Are you under warranty? I would consult with the manufacturer for further resolution regarding your air conditioner. I hope this information has been helpful. -Matt

Your Frigidaire window unit is the same as any other window unit. Typically window unit air conditioners don't have a drain. This is why you have to make sure the back of the unit (the end that goes outside) is slightly lower than the front when you put it in a window. When it gets so high with water it drains out the back onto the ground.

Your unit (B3BV-036K-BB) is a Westinghouse / Nordyne Unit. Vertical Flow only, 36,000 BTU, 208/230 volts. You cannot tell the manufacture date from a model number, only from the serial number. Try contacting manufacture with the serial number... (nordyne.com)

Hey friend, thanks for your inquiry!

The sytrofoam inside the air conditioner is part of the duct work and it also helps to hold colder temperatures. The new air conditioners do not have drain holes but instead recycle the water inside your appliance to help cool the internal components. I hope this information is helpful. -Matt

Good morning jesse dixon, I appreciate your post!

Based off the information you have provided your Frigidaire air conditioner, FRA123CV1, cutting off every three minutes and then flashes "#88" then it will go back to the normal setting. Sounds it could be a possible issue within your control panel or power cord. Are you currently under warranty? If so, you might want to reach out directly to the manufacturer to determine the coverage on your air conditioner and the procedures to any potential remedy. I hope this helps to some degree. -Matt

Hey friend, thank you for your inquiry!

I see you have recently changed the PC board inside of your Frigidaire air conditioner, FAM186R2A2, and now your appliance will not come on. It sounds like you could be having a potential issue within your power cord or another issue within that board. I would recommend having a professional come out to diagnose your appliance to avoid any further unnecessary part purchases. Hopefully this is helpful. -Matt

Hey friend, I appreciate your post!

I see that your Frigidaire air conditioner will start up then shut off and blink. It could possibly an issue with control panel or the power source of the appliance. I would attempt to perform a reset on the air conditioner which would be removing the plug and pressing the "Test" button, you will hear a click and the button will pop out. Then press the "Reset" button, you will hear another click then plug the appliance in. Those are the steps to resetting your air conditioner, if that does not successfully correct the problem please reply back. I look forward to your response. -Matt

Hello Friend, this is Z. I appreciate your post! From what you have described, it appears that your air conditioner may possibly be experiencing a communication problem with the control board or a potential wiring failure. Since you have already tried resetting your air conditioner, at this point I recommend reaching out to a professional to properly diagnose and repair your appliance.

Good Morning Friend, thank you for question! I see that your post is listed under Frigidaire air conditioners and that you are receiving an error code OS. In order to better assist you, I would need your model number please. The serial tag, which lists your model number, is typically located behind the front grill by the air outlet or on the inside of the cabinet. Other possible locations for the tag on a room air conditioner is on the front edge of the chassis base or behind the dial plate of the control panel. If you have a split air conditioner, try checking on either the front or outer appliance on the right side of the cabinet. Thank you and I look forward to your response! - Z

Good Morning Friend, this is Z. Thank you for your post! I see that your question is listed under Frigidaire air conditioner and you are inquiring about how to empty the drain bucket. However based on the picture of the model (split-air conditioner) shown above. I do not see it has a drain bucket. May I have your model number please? You can normally find the serial tag (which lists your model number) on the right side of the cabinet on both the inside and outside appliance. With this information I can better address the issue at hand. Thank you!

Hi friend, that's a great question!

To reset your Frigidaire air conditioner you would need to make sure the appliance is turned off and unplugged. On the power cord you will see a test button, push that button and you will hear a click. You would then press the reset button you will hear a click again signifying that the appliance has been reset. Then plug your air conditioner back in and it should be reset. -Matt

First determine if the pump/compressor is working. If not, there's your problem. Needs repair done by a shop. Well, really, only a shop should be repairing Ac units due to certificatios,equipment and EPA refrigerant recovery regulations. Sorry. -Ned_

Hey friend, that's an interesting post!

Based off the information you have provided your air conditioner is continuously shutting off and coming on by itself. It may be an issue with the power source of the appliance, the plug, or the control board. Because it could be a number of any one of several underlying causes, I would recommend reaching out to a professional to properly diagnose and repair your air conditioner. Best regards-Matt

Hello Friend, this is Z. Thank you for your post! I understand that your inquiry is listed under Frigidaire Air Conditioner and that you would like to know what type of Freon 5695 is. You may typically locate information regarding the Freon on the serial tag (which lists your model number) of your air conditioner. You can normally find the serial tag behind the front grill by the air outlet or on the inside of the cabinet. Hope this helps!

what brand and size is this aircon