20 Most Recent MTX Thunder 6000 T61544A Car Subwoofer Questions & Answers

Depends on where it is but if it is in the middle of the cone, you can use a light weight plastis and glue it over the hole or if it is a really small hole, a piece of tape o. The backside and some epoxy or jbweld on top. The tape just keeps it from leak in g thri ugh while the glue dries

MTX Thunder 6000... | Answered on Feb 28, 2013

1 Answer

Where can i find a

You would have to look for a re coning kit from either MTX site or amazon or ebay

MTX Thunder 6000... | Answered on Aug 22, 2011

1 Answer

How to bridge a 12

I assume that the sub is a dual 4 ohm and you want a 2 ohm load. It's easy. Just make sure that both positives go to the same positive source and both negative go to the same negative source. It's called a parralel set up. hope this helps

MTX Thunder 6000... | Answered on Aug 22, 2011

0 Answers

My mtx audio thunder 6000

MTX Thunder 6000... | Posted on Jul 29, 2011 | Be the first to answer

1 Answer

How big of hole do i need for the mtx 6000 thunder

The MTX Thunder 6000 T61544A is a 15" Subwoofer meaning you will need a 15" hole to fit the subwoofer into. The mounting plate that surrounds the subwoofer will extend past 15" allowing you to screw the sub in properly. Be sure to use a box that is at least 12 inches deep (sub is 10 inches deep by specifications + 2 inches for good air cushion behind.

MTX Thunder 6000... | Answered on Mar 04, 2011

1 Answer

Mtx 8100d, how do I hook up ?

power to-battery plus

ground;;

remote''

MTX Car Audio &... | Answered on Nov 05, 2019

1 Answer

What are the red lights on my mtx tna251 amplifier

THE GREEN LIGHT SHOULD SHOW WHEN AMP IS POWER UP AN RED WHEN IN PROTECTION MODE

MTX Car Audio &... | Answered on Sep 12, 2019

1 Answer

Where can i get a Manual for a mtx 600 watt terminator amplifier its a tna251

Try eBay Often available there from private sellers

MTX Car Audio &... | Answered on Aug 25, 2019

1 Answer

I have a mtx tunder series 942 when you hook it up the red light comes on I have the best wire and have checked everything the amp is old school it does have a fuse on it I have one on my power line pls help!!!!!

I was having a similar issue. I checked every wire from the battery to stereo to amp, checked the ground, pulled the stereo to double check the wiring was all correct. Everything seemed good so I thought it had to be my battery not putting out enough power. Tested it and it was good. What it turned out to be was the connection from the power cord to the battery. It had a tiny bit of built up corrosion that was making the amp go into protect mode. Cleaned it up and hooked it back up and has been golden since.
The link attached is pretty straight up on what you need to check for different circumstances. I'm guessing it's a low voltage issue. Good luck

MTX Car Audio &... | Answered on Aug 23, 2019

1 Answer

I have 3 x 10 inch MTX RT10XDS subs in an enclosure, with a pair of 6x9s 500w pmpo and 2 mids.Whats the best way to wire to the Lightning Audio Strike amp S2.500.4???

you have to first note the ohm load the amp can handle and wire the speaker that ther amp can handle

MTX Car Audio &... | Answered on May 13, 2019

1 Answer

Okay mtx 4501 lights up no sound

Check the wiring 1st then go down the line...Check speaker connections..Look at your power,ground and remote wire hook up

MTX Car Audio &... | Answered on Oct 18, 2018

0 Answers

There are 3 lights on my mtx 251 amp that dont come on but the bass still works why

MTX Car Audio &... | Posted on Aug 28, 2017 | Be the first to answer

0 Answers

My mtx amp 3 lights are out but the bass still works why

MTX Car Audio &... | Posted on Aug 28, 2017 | Be the first to answer

0 Answers

2002 Dodge Ram radio (not infinity) shuts off after being on for 6-7 seconds.

MTX Car Audio &... | Posted on Jul 13, 2017 | Be the first to answer

1 Answer

How much does mtx psw101b cost

Since this is a vintage item, the cost is whatever the market will bear, wherever you're trying to sell it. I would suggest checking current prices on sites such as eBay, where one is currently being offered to sell at $200, while another is being offered for $90. The perceived value is what determines the selling price at this point, because the MSRP is long irrelevant by now, being that it's a discontinued item.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/reginald_bec291de192ca44f

MTX Car Audio &... | Answered on Jul 08, 2017

0 Answers