20 Most Recent Equator EZ 3720 CEE Questions & Answers


repair clinic.com

or try ebay for cheaper parts

Equator EZ 3720... | Answered on Feb 02, 2016


replace transmission , control board or timer

Equator EZ 3720... | Answered on May 14, 2015


do you mean the door latch , google the door latch as its easily replaceable an obtained

Equator EZ 3720... | Answered on May 19, 2014


Unfamiliar with these machines. The dryer portion probably works like any other condenser dryer so that means it has a condenser which is used to remove the water from the warmed air. If the condenser is clogged and in need of cleaning the drying mode will suffer. The lint filter should also be cleaned. Like I said I never even saw one up close.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Equator EZ 3720... | Answered on Nov 04, 2011


HI, check the following to address this issue.

1. Clogged drain line or water pump
Check to see if there's something stuck inside the pump or the drain hose connected to the pump (pump is usually located at the bottom and towards the back of the washing machine).

2. Water Pump
If the drain line isn't clogged, you may have a problem with the water pump such as a frozen pulley or a broken impeller. If that's the case replace the water pump. Note: if you have a belt driven washer, check the belt(s) for cracks, as this would be a perfect time to replace the belt(s) if needed.

**The most common issue will be an obstructed hose or, line

NOTE-If the hoses and pump check out ok, this will confirm that there is a serious within the actual control sector(Timer module or control board). It should be replaced i this case.

Equator EZ 3720... | Answered on Nov 04, 2011


Check for a build up of lint in the exhaust duct, an excessive build up will block air flow.

Also 220VAC electric dryers use different legs of the electrical supply. (two 110VAC legs tied via a common neutral make 220 VAC) One 110VAC leg runs the motor and controls while the other supplies power to the heater.

It is possible that one side of the 220VAC has a blown fuse and is not supplying power to the heater element.

Other possibilities:

Blown out heater - requires replacement

There is a safety switch attached to the shaft of the motor. THis switch relys on centrifical force to close and is intened to kill the power to the heater if the motor and its attached blower stop turning.

If the motor is not turning fast enough of the switch is worn then it is possible that power to the heater circuit is not being completed. It doesn't take must of a speed reduction to cause a problem. Lint build up on the drum bearings can cause enough drag to slow the drum slightly. Combined with a worn/dirty switch and the switch fails to operate.

Finally there is a blower attached to the motor shaft. The blower is made of plastic and somtimes the blower comes loose on the shaft. Usually you hear a rattling sound or sounds after the dryer drum stops as the loose spinning blower spins to a stop. ( A tight blower stops with the dryer drum) A loose blower doesn't move enough air and causes your dryer to run longer.

Equator EZ 3720... | Answered on Jul 28, 2010


Normally, the machine should be placed on a stable levelled surface, placing it on a dolly and running it for a few minutes should not make a huge impact on the machine, however there is a possibility that some parts in the machine may go bad due to the vibrations caused, it can only be understood if the machine when run on a stable surface works fine or not.

Also, do confirm that the shipping bolts were removed from the machine during the installation.

Equator EZ 3720... | Answered on Jul 20, 2010


If you are still looking for a solution to this you may want to check where is the unit exactly leaking from, open the back panel and check if the there is any hose that has got disconnected.
You may also want to check if the coin trap cover is tightened properly.

Equator EZ 3720... | Answered on Feb 26, 2010


No, only the dryers can be modified.

Equator EZ 3720... | Answered on Jan 08, 2010


Hi,

You could Download the manual from :-

http://www.equatorappliance.com/ownersmanual/3720%20-%20Owner%27s%20manual.pdf

You need to have Acrobat Reader to View this.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Equator EZ 3720... | Answered on Jan 08, 2010


where are you located???? if your close by call us at 24/7 Appliance Service in Southern Wis. (608)214-5632

Equator EZ 3720... | Answered on Oct 04, 2009


If you can see water in the tub, the machine is not draining the water out, and preventing the door from opening,
It could also be a faulty door interlock switch.
I hope this helps?

Equator Washing... | Answered on Sep 10, 2019


the problem is that you are installing what may not be faulty
get a service technician out to check the problem as it could be a program board or other sensor that is faulty and you are replacing the symptom and not fixing the fault

Equator Washing... | Answered on Aug 10, 2017

Not finding what you are looking for?
Equator EZ 3720 CEE Logo

18 questions posted

Ask a Question

Usually answered in minutes!

Top Equator Washing Machines Experts

Brad Brown

Level 3 Expert

18136 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

lectricjohn

Level 1 Expert

16 Answers

Are you an Equator Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Equator Washing Machines

  • Equator Washing Machines

Most Popular Question

order parts

  • Washing Machines
Loading...