20 Most Recent
Hoover Steam Vac Dual V w/ SpinScrub Vacuum - Page 4 Questions & Answers
How do we get at
There is no belt in a Hoover SteamVac. The brushes are turned by an air driven turbine. If the brushes are not turning, it is usually because the turbine has seized up and may need replacement. Insert a screwdriver into the square hole that the pin on the brush assembly normally fits into and see if it turns. If it doesn't, you will need a new turbine.
I have a Hoover Steam
your belt is probably brokan. underneath the machine you will see some screws carefully take them out writing down which screw went where. than you can pop the plate off and look in there and see if your belt is brokan. If it is the belt number is important to find in your book that came with the machine. hope this helps you.
How do you hook up the hose
Hello There,
Here's instructions on how to use the hose assembly on your Hoover SteamVac Dual V:
UNPLUG THE UNIT FROM THE WALL.
Attaching The Hose
- Open Hose Connection Port (Figure A).
- Insert Short Hose End, Matching the tabs on the hose with the same-sized slots in the connection port.
- Plug Hose into Port and twist to lock it in place.
- Plug the solution Tube that protrudes of the suction hose into the solution connection port (Figure B)
Removing the Hose
- Squeeze Latches (Figure C) on top and bottom of the hose. Remove hose from port. Close the Hose port door.
- Remove the solution Tube from the Solution connection port by pressing on the white latch.
I hope that this answered your questions. If you have any other questions on hose to use your hose, please feel free to use the comment box at the bottom of the page. I'm always happy to answer any of your follow up questions. If you found this repair helpful, please be so kind and rate the repair helpful, or by leaving feedback. This is very appreciated by the FixYa community and is what keeps repair experts like myself continue to answer free questions, instead of just answering the premium questions in which you have to pay. Thanks so much.
Chris Jones
GoVacuum.com
I have a Hoover Steam
You will need a new valve assembly. ( part # 43513014, msrp $3.62 ) Place the rubber seal in first, then wet the valve and push it in with your thumb.
My Hoover steam vac dual
This is a common problem with the earlier models which had a separate soap tank glued to the clean water tank. The plastic was too thin beneath the valve on the clean water side and would develop cracks. You most likely will need a new one piece tank. ( Part # 42272104)
Picture you sent for me
The solution tank injects the cleaner depending on the selection you have make such as light or heavy. You fill the tank with cleaning solution.
Not finding what you are looking for?