20 Most Recent
MTX T-Form04-05 Chevy Colorado Gray w/10'' sub Car Speaker - Page 4 Questions & Answers
How to wire MTX 202 amp
this link has install sheets just match the model number of you amp to the list of mtx amplifiers to find appropriate wiring diagram
http://www.mitekasia.com/support/Default.aspx?sid=257&aid=2
81000d missing resistor
you need the resisitor, it keeps the machine from basically frying up in case of a power surge.,
I have a mtx thunder 7801 series amplifier well i got a stereo from someone and i didnt know it a the time but it had the wrong plug in the back of it so when i hooked my amp up to it what i thought w
The short answer is probably yes... easily, probably no. If you are lucky and only have one or two shorted transistors, then you can cut the leads on those and see if it powers up without blowing a fuse. Also check for shorted diodes and burnt resistors. If all FETs (or most of) the FETs mounted to the heat sink are shorted then it is probably not worth taking the chance putting the time and money into fixing it, just to have it smoke again. Also they are likely in parallel so it is a little more difficult to determine the bad one as they may not all be bad. Measure with an ohmmeter and find the one with the lowest resistance and remove that first and keep going until you believe you have gotten them all. Normally repairs like this are not for someone with little or no experience on amp repair, but if you feel like taking it on, good luck!
I have 2 different subs in one box, a 12" MTX
im guessing both speakers are 4 ohms ..mtx 4ohms and kicker dual 4ohms..now if your amp can go down to 1 ohm wiring the kicker dual coils in parallel (2ohms) and the mtx connected together (4ohms) should leave you with a final impedance between 1 and 2 ohms ...i suggest you use one or get another
Not finding what you are looking for?