20 Most Recent Lenovo 3000 N200 Notebook - Page 4 Questions & Answers

I just had the same problem. My battery had discharged to less than zero and would not start even though the power plug was in. I tried everything... but what fixed it for me was to remove the power plug, remove the battery, plug in the power cord and start the machine. Once the machine was already booted, I put the battery in and it started charging. Dont know if that will fix your problem, but it fixed mine.

i think there is problem with the head of the dvd player or may be dust particles inside clean it

You need to buy a new screen

System restore is the best possibility

if you can identify the network card contact the vender and c if they have a vista driver available. but until then u should be able to roll back your vista install go to add remove programs and u should see option to uninstall vista this puts your win xp back on you system. once u get xp back go to vendors site and save vista driver to disk for you nic(network interface card) u can then reinstall vista and then install the driver for your nic

No switch outside, it is a software thing. Go into the control panel and click on the wireless tab and repair connection.

not capable of sleep mode, some units just dont have that feature available.

You will have to adjust this under display properties.If the adjustments there fail.Uninstall the drivers in device manager and reinstall them

Ram or power plucking problem.......fit it correctly and reboot ur system now

The issue is, the motherboard is faulty. You will need a systems engineer to look at it. Some chips are burnt and should be replaced. The only other alternative is to replace the entire motherboard.

make sure the num loc is off

plz post complete question ...
like....
1)you have installed multiple os on your system or not..
2)file system of c drive ...
extra......

Take the back panel off by undoing the screws ,then un-clip the keyboard & under it you will see a ribbon cable going to the main board theirs two little clips on both sides where it joins, lift them up with your finger nails then push the ribbon in untill it's straight & all the pins are back in then clip it back down.test it before you put it back together.
other than that clean under the buttons with some contact cleaner & a cotton bud..
GOOD LUCK........

downgradeing is not the best thing to do i know ive dont it
xp and vista and most other companys will not supply the drivers
your only chance is to serch the web for a driver /you should be able to get a driver compatable off the web site for your laptop

My friend, the easiest and by far the best way I have seen is to set the advance timings on your laptop just right and use a vga to scart cable.

Restart your Laptop to recognize again your TV on the system.

For info on fixing, service, parts and DIY info
Check out LCD Parts WEB site, click on this link :-
www.lcdparts.net

here's all the drievrs available for this laptop http://www-307.ibm.com/pc/support/site.wss/document.do?sitestyle=lenovo&lndocid=MIGR-67855

check your CCFL inverter and LCD connectors.

surround your computer with dog food and they will come out on their own!