20 Most Recent
Zebra 203DPI Printer - Page 3 Questions & Answers
Zebra LP 2844-Z permanent IP Resolution how to change
If you are unable to change the IP address of your Zebra LP 2844-Z using the ^default command or Zebra Utilities, and updating the BIOS did not help either, you may need to try a factory reset of the printer.
To do this, follow these steps:
- Turn off the printer.
- Press and hold the feed button on the front of the printer.
- While holding the feed button, turn on the printer.
- Wait for the status light to turn solid red, and then release the feed button.
- The status light will blink green a few times, and then turn solid green.
- Press and release the feed button once. The status light will blink red a few times, and then turn solid amber.
- Press and release the feed button again. The status light will blink green a few times, and then turn solid green.
The printer should now be reset to its factory settings, including the default IP address of 192.168.168.168. You should now be able to access the printer through this IP address and change the settings as needed.
Zebra 6M Plus Shows "Checking Onboard Flash"
It sounds like there may be an issue with the onboard flash memory on your printer. Try performing a factory reset (hold down the pause and cancel buttons during startup) to see if that clears the problem. If not, you may need to contact Zebra customer support for further assistance.
Cannot delete print job queue Zebra S600
hi
How do I force a print queue to delete?"); display: inline-block; height: 24px; width: 24px; margin-top: -1px; transform: rotateZ(-180deg);">
You can clear the print queue using commands like this.
- Select Start.
- Type Command .
- Right-click "Command Prompt" and select "Run as administrator".
- Type net stop spooler then press "Enter".
- Type del %systemroot%\System32\spool\printers\* /Q then press "Enter".
- Type net start spooler then press "Enter".
Not finding what you are looking for?