I removed the rubber infill that covered a hidden screw. Released screw and then removed back plate. Removing the battery then required care as it is stuck with two sided tape to the Mio internals. Here I used a knive to prise/cut free.

Read full answer

Mitac Mio P550... • Answered on Jul 04, 2011

2 Answers

I need the manual io use it as MP-3 player.

try using it without a manual this way you can not get something wrong unless it is very doubtful. and you will tend to get use to it quicker

Read full answer

Mitac Mio P550... • Answered on Jul 03, 2010

1 Answer

Can't put Mio P560 in bootloader mode

up arrow + power_on until MIO logo

Read full answer

Mitac Mio P550... • Answered on Jun 03, 2010

1 Answer

Device formatted in error

http://forum.xda-developers.com/archive/index.php/t-277374.html

Read full answer

Mitac Mio P550... • Answered on Mar 21, 2010

1 Answer

Cannot start my pda p 550 window .suspect os

try to restore it to the last working state, remove all cables, slide the switch to off position, wait 1 minute and slide it back on.
once it opens, make a clean boot to erase the errors encountered by your pda and restore it back to its factory setting.

good luck...

Read full answer

Mitac Mio P550... • Answered on Feb 24, 2010

1 Answer

How can i subscribe a GPRS settings

how can i subscribe a GPRS settings for my china phone?coz i dont know.. its too hard..

Read full answer

Mitac Mio P550... • Answered on Jan 31, 2010

1 Answer

How to open mio P560 for changing battery

I have just replaced my battery in my Mio p560. On the back of the Mio at the top - remove the two small rubber bungs, you will see the screws underneath. On the back at the bottom you must remove the alluminium strip to get at the remaining two screws. This is the only tricky bit! The strip has the hole for the pointer on the right, with a small screwdriver prise up the LEFT side of the strip, it is stuck down but will come if you are gentle! Then you can detatch the strip at the right side. The two bottom screws will be under this strip. remove the four screws now. The FRONT of the Mio can then be separated from the back, it just clips along the sides. The battery can then be got at and exchanged. When you re-assemble make sure the on/off switch locates properly. Thats it! Regards David Harford

Read full answer

Mitac Mio P550... • Answered on Jan 21, 2010

1 Answer

How to connect Mitac Mio P550 to a PC?

if you have xp you will need to download microsoft active sync from www.microsoft.com and if you have vista you will need microsoft sync centre, these will be the latest versions and should work fine good luck

Read full answer

Mitac Mio P550... • Answered on Aug 09, 2009

1 Answer

I have a Mio digi

It sounds like the device is not reading the ROM card at all. This most likely is not a home type fix. Check your warranty and see if there is a solution there.

Read full answer

Mitac Mio P550... • Answered on May 16, 2009

1 Answer

Shut down and looses the date and the hour

Your battery is dead...replace it or see if it's still connected to it's connector( by removing the battery cover that have one screw hidden )

Read full answer

Mitac Mio P550... • Answered on Apr 10, 2009

1 Answer

MITAC X-200/12V POWER SUPPLY wont turn on

Be the first to answer

Mitac Computers... • Posted on Aug 15, 2019

0 Answers

My mitac not start

what is it, posted to computer repair help is too hard to tell what it does first? animal vegetable mineral?>(classic joke) the only clue is start, (cards starts, boats and plains or anything with and engine) that? the dictionary shows this. omg. list Acronym Definition MITAC Mining Industry Training and Adjustment Council (Canada) MITAC Major Industries Training Advisory Council (Darwin, Northern Territory, Australia) MITAC Map Interpretation and Terrain Analysis Course MITAC Microcomputer Tactical (aid) MITAC Marine Industries Technical Assistance Service Center MITAC Massachusetts Institute of Technology Activities Committee 50 hits on google down the endless list of this name, I find Mitac PD12TI CC Mini-ITX Motherboard w/ Intel Atom D2500 CPU, Dual LAN, D2500CCE (just wild guess but betting clues and unstated by YOU) ok that is a computer. sure it. a micro iTX PC. with ATOM POS CPU. found their home page next https://mitxpc.com/products/pd12ti-cc-d2550 SO WON"T start means? My guess will not turn ON. what: VGA port dead powered on>? there support page SUX, no manuals at all. runs only windows 7 32bit, and that is now obsolete, I found manual on line, on mirrored sites it uses 24pin 2x12 PSU power supply. power. to turn it on , jumper 2 pins on the header "P" 2x5 pins 6 to 8 jump turns it on. X = KEY 2468X 13579 https://www.cartft.com/support_db/support_files/Mitac_PD12TI_Manual.pdf

Read full answer

Mitac Computers... • Answered on Jun 28, 2019

2 Answers

Need to verify if my

Probably not too much help right now, but you can get a small device online for just that purpose. Try shopping for "computer power supply tester" Less than $5 including shipping.

Read full answer

Mitac Computers... • Answered on Feb 10, 2018

1 Answer