Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher - Answered Questions & Fixed issues
Whirlpool gold quiet partner IV
You probably need to clean the filter; here is a site to show you how to do it: http://01tutorials.com/video/1686251/how-to-clean-the-filter-on-a-whirlpool-gold-quiet-partner-iv-dishwasher/4107
Detergent sticks in main wash compartment
Jsmarquez, We would like to inquire further about your post with you. Please respond back to this email address
[email protected] with your name, user id (Jsmarquez), phone number, street address, zip code, reviewer name, model & serial number, and date of purchase on the appliance.
Dishwasher will not stop filling with water
Failure of the water INLET valve if fails to stop the flow or it is due to constant supply from the controller unit to the inlet valve.You can confirm this by checking the voltage on the INLET valve, if voltage is continuous it is the board and if the voltage cuts but the flow continues the valve is struck.
Timer wont advance
timer is bad. if you go to www.searspartsdirect.com , you can enter your model # and find the part #. then google the part #, you should be able to find it pretty cheap. easy to replace.
How to remove the filters
Under the bottom plate there should be a screw in filter .The top should be visible .Graspping the top turn counter clockwise into it is free. Clean and replace.I found a dish scrubber brush to be the best way too clean the. Filter
Remove upper rack
When you pull the upper rack forward, the two metal glides on each side move forward. On the end of each glide is a white plastic end cap. If you look through the rack to the inside of each glide, you can see that the upper part of the end cap has a upper tab. I put my thumb on the end cap then press the upper tab forward with my index finger. Then press upward with your thumb and the end cap should slide totally upward and then out of the glide. Once both end caps are removed, the upper rack slides fully out of the washer.
Flashing clean light
check behind kick plate for service manual. To clear 7 blinking lights go into diagnostic by doing a finger dance, touch hi temp scour then air dry till it goes into diagnostic this will check all systems .Once finished you will most likely need to change the chopper and junk in or around the sump Cheers
Whirlpool Dishwasher will fill water then stops
If it fills with water properly then stops, and especially if there is a humming noise, it is possible that- motor start capacitor has failed- drive belt has slipped or snapped- belt tensioner spring has broken
No indicator lights Whirlpool wdt710paym dishwasher
If it doesn't run and you have no indicator lights, check the circuit breaker for that outlet. If it is ok, test the output voltage at the plug-in for the machine (115Vac). If it is "live" then check inside the control panel (turn off the breaker first) for a fuse that appears blown. If no fuse problem, CAREFULLY (with breaker back on) see if the main switch is getting power. If it is getting power, the control board is shot...replace it!
Microwave over oven starts but turns off in a few seconds when oven is hot.
Likely thermal shutdown. Insulation may be missing or out of place between microwave and the oven itself. If you see foil, that is radiant barrier, and if it is damaged, it raise the temps in the microwave cabinet enough to cause this.This assumes no arcing or other audible or visible issues and microwave just "drops out".
Not finding what you are looking for?