Sylvania LD370SS8 37 in. LCD Television - Page 7 - Answered Questions & Fixed issues


Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Sylvania... | Answered on Feb 18, 2017 | 105 views


You have a shorted circuit board.

Sylvania... | Answered on Feb 15, 2017 | 31 views


Hi
A common problem for these is bad capacitors in the power supply, Remove the back from your TV and look at the power supply on the left hand side.

You will see roughly around 9 x capacitors that are bulged / domed shaped on top usually these are valued at 3300uf 10V any that have bulged or leaked a brown like substance should be changed.
This will cure the problem as they overheat being sat next to a heatsink that gets very hot!
Try and change them for the same 3300uf but a higher voltage.
Hope this helps and be careful in handling the television because it contain high voltages.....

Sylvania... | Answered on Feb 11, 2017 | 112 views


If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.

Sylvania... | Answered on Feb 10, 2017 | 268 views


Yes, it can be repaired but is it cost effective?

Sylvania... | Answered on Feb 10, 2017 | 136 views


Those blinks are fault indications. From the number of blinks you can get an idea about the fault circuit board. If you wish to get more details visit the site linked. Blinking codes of many popular brand sets are given in detail. http://electronicshelponline.blogspot.com/

Sylvania... | Answered on Feb 10, 2017 | 93 views


Corrupted firmware. A firmware update is necessary. Contact any service technician. If you wish to get more details visit the site linked here. http://electronicshelponline.blogspot.com/

Sylvania... | Answered on Feb 10, 2017 | 33 views


You need a digital to analog cable box or you will get reception, they are cheap and available on eBay.

Sylvania... | Answered on Feb 09, 2017 | 45 views


You are going to need a digital converter box for antenna reception and that box is going to have to come with S-video or composite V and A rca style jacks. Look on amazon or ebay.

Sylvania... | Answered on Feb 09, 2017 | 34 views


Check the speakers. If found OK, check and replace damaged components at its audio output stage circuit. If you wish to get more details visit the site linked here. http://electronicshelponline.blogspot.com/

Sylvania... | Answered on Feb 09, 2017 | 30 views


It is the little glass bead in the middle of the transport mechanism

Sylvania... | Answered on Feb 01, 2017 | 64 views


Send it anywhere you like.

Sylvania... | Answered on Jan 25, 2017 | 65 views


Without a remote control, you can't select its functions. If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one.
To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability. Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device brand you have.
Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its pack. Never accept a remote control, that hasn't both of this. For more details about the set-up codes, visit the sites.
http://homenol.blogspot.com/
http://electrohelponline.blogspot.com/
http://remotesearch.blogspot.com/
Universal remote controls are available at most of the electronic spare part selling shops. Visit some on-line sites too, which deals with electronic spare parts.
If you wish to get further advice over phone; visit https://www.6ya.com/

Sylvania... | Answered on Jan 19, 2017 | 42 views


If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one.
To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability. Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device brand you have.
Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its pack. Never accept a remote control, that hasn't both of this. For more details about the set-up codes, visit the sites.
http://homenol.blogspot.com/
http://electrohelponline.blogspot.com/
http://remotesearch.blogspot.com/
Universal remote controls are available at most of the electronic spare part selling shops. Visit some on-line sites too, which deals with electronic spare parts.

Sylvania... | Answered on Jan 17, 2017 | 37 views


Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. The site has set-up code list & set-up procedure to many popular brand remote controls. The site has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Set-up code list to many brand remote controls also is given. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily.
http://homenol.blogspot.com/
http://remotesearch.blogspot.com/
http://electronicshelponline.blogspot.com/
http://electrohelponline.blogspot.com/
Programming Notes
• If your device does not respond to the remote after trying all codes listed or your brand is not listed in the code list, use the Auto Code Search method to program your remote.
• Sometimes the first code that "works" with your device may operate only a few functions of your device. There may be another code in the code list that performs more functions. Try other codes from the code list for more functionality.
This is a trial and error procedure; and quiet time consuming. You might have to check different codes said for your device.
Search the site by type in the "brand name" to your device; to which you want set-up codes; in the "Search box at the top right of the display window" to get gathered related posts.

Sylvania... | Answered on Jan 17, 2017 | 31 views


im wondering why you did not connect it to the tv ?? but instead to cable box , does it have a pass thru capability ?? does it need to be off to pass thru ?? as most dvd player don't have a rf output but instead use a hdmi or composite signal output , would it not be easier to connect one of these to a spare input on tv then when u want to use dvd you only need to select the proper input from tvs source button to view the dvd ??

Sylvania... | Answered on Jan 10, 2017 | 84 views


Sylvania 0020 0054 0186 0028 0030 0171 0381

Sylvania... | Answered on Jan 09, 2017 | 41 views


If you wish to get some details; visit the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
http://schematicscom.blogspot.com/
Circuit diagrams of many popular brand TVs and other devices are given.

Sylvania... | Answered on Jan 02, 2017 | 84 views


0054, 0030, 0020, 0096

Sylvania... | Answered on Dec 28, 2016 | 238 views

Not finding what you are looking for?
Sylvania LD370SS8 37 in. LCD Television Logo

71 questions posted

Ask a Question

Usually answered in minutes!

Top Sylvania Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76416 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

matt martin
matt martin

Level 3 Expert

1258 Answers

Are you a Sylvania Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...