Kyocera FS-2000D Laser Printer - Answered Questions & Fixed issues
Any clue what error code 6030 is?
I had the same problem. Pull the Fuser and check Conector.Sometime pieces of paper inside the Conector raises an error.
Please Rate .
How can i see the serial number or how do i reach it cause i cant
press manu button then go to service then press right errow key goto status page press double enter it will print around 5 or 6 page in second page in down you can find the serial number or else see the back side of the printer it should stikared.............
"add paper cassette"
Turn the printer off. Pull the paper cassette out and push down the green tab down to see if there is any paper jam inside. put the cassette back in and turn the printer on. Worked on my kyocera FS - 1370 DN.
What is C6030 on Kyocera Km-C2520
6030 Broken fuser thermistor M wire
*35/37 and 45/47 ppm printers (EUR/
USA model) only
Input from fuser thermistor M is less than
1 (A/D value) for more than 3 s.
Poor contact in the
fuser thermistor M
connector terminals.
Reinsert the connector (See page P.1-5-19).
Broken fuser
thermistor M wire./from the manual try replacing thermistors then reset the code or just replace fuser then reset the code
from the manual sadjnbdsvknsdlkvnsdv
Call service 7410:0711657
Open top and front cover and remove Developer Unit. Next, open the left cover (at the waste toner box), remove waste toner box. Unlock the drum unit lock and then remove the drum unit. If the printer is dirty inside, clean it with vaccum cleaner. Be carefull with the drum surface, not to scratch it. Put the Drum Unit into a dark place if you remove the unit for a longer period of time. After you cleaned the printer inside, put the Drum Unit back. Dont forget to push the unit firmly, for good electrical contact. Put all the other components back and turn on the printer.
Printer marks on paper
remove drum /toner unit look at it, it most likely is the problem, is there a line or spots on the shiny surface? clean with soft cloth. otherwise will need to replace. If not that it will be the fuser, back of machine where it gets hot to melt toner to paper.
Not finding what you are looking for?