Top 20
Kyocera FS-2000D Laser Printer Questions & Answers
What is C6030 on Kyocera Km-C2520
6030 Broken fuser thermistor M wire
*35/37 and 45/47 ppm printers (EUR/
USA model) only
Input from fuser thermistor M is less than
1 (A/D value) for more than 3 s.
Poor contact in the
fuser thermistor M
connector terminals.
Reinsert the connector (See page P.1-5-19).
Broken fuser
thermistor M wire./from the manual try replacing thermistors then reset the code or just replace fuser then reset the code
from the manual sadjnbdsvknsdlkvnsdv
Call service 7410:0711657
Open top and front cover and remove Developer Unit. Next, open the left cover (at the waste toner box), remove waste toner box. Unlock the drum unit lock and then remove the drum unit. If the printer is dirty inside, clean it with vaccum cleaner. Be carefull with the drum surface, not to scratch it. Put the Drum Unit into a dark place if you remove the unit for a longer period of time. After you cleaned the printer inside, put the Drum Unit back. Dont forget to push the unit firmly, for good electrical contact. Put all the other components back and turn on the printer.
Printer marks on paper
remove drum /toner unit look at it, it most likely is the problem, is there a line or spots on the shiny surface? clean with soft cloth. otherwise will need to replace. If not that it will be the fuser, back of machine where it gets hot to melt toner to paper.
Kyocera FS-2000 dn error 7410-0001163 What is the problem ?
Call Sevice 4710 means the Connection between fhe Drum-Kit DK310 and the DV 310 is broken.Open the Door on the left side, and push the Drum DK310 into the printer, so you here a klick,Power off the printer and then power on the printer.The Call 7410 Message is away, the Numbers after 7410 are the pages of printing
Not finding what you are looking for?