Braun 5270 Epilator - Page 3 - Answered Questions & Fixed issues

Hello, Unfortunately, E01 is an error meaning a problem with a component internally that is not repairable. Please contact the customer service team for further .

https://www.youtube.com/watch?v=5_MMBhtmPEQ

The drive unit is probably not seated correctly. It must be pushed down when reassembling in order to keep the motor contacts in the correct position until the case is secured

shaveroutlet.com does repairs. email them at [email protected]

If error persists reset the thermometer by removing the batteries and putting them back in. If error still persists contact your Welch Allyn representative. To change default temperature scale: With the device off, press and hold the button for about 5 seconds. Release the button when desired scale is shown.

https://www.manualslib.com/manual/1177527/Braun-Perfusor-Space.html?page=2#manual

Lot of complaints about this piece of junk. Lot of charging issues like your having.
Take it back and demand your money back.

Check out yhe reviews on the Braun website. As low marks as you can get.

https://us.braun.com/en-us/beard-trimmer-bt3020/reviews

To answer the original poster's question: The output specs of the power unit are 12V, 0.4 amp. These specs are used on dozens of Braun shavers.

This model is long discontinued and no longer available. A similar model can be found at shaveroutlet.com https://shaveroutlet.com/braun-p-70-pocket-go-aa-batteryoperated-travel-shaver-p-124.html

http://www.electricshaverstore.com/s/1/mens-shaver-parts_p_3/c_braun+5428.htm may try ebay amazon

Hello, Eugnene - See eReplacementParts.com: https://www.ereplacementparts.com/braun-5614-5723-flex-parts-c-120570_120578_120883.html Best wishes.

you broke something

Your shaver is a 'Series 9' type. There are many Series 9 models. Only the models with 'cc' following the model number are compatible with the clean and charge station. Models with 's' following the model number are NOT compatible with the cleaning stations

Possible bad battery

It is hard to say for sure which component on the circuit board is burned. But, if the shaver will not work after putting the battery in the correct way, it has been damaged beyond repair. It is a little late for this advice but it is always a good idea to note the polarity of the battery before removing the old one(s)

you can look at this sight and look for you model and see a user manual. http://personalcare.manualsonline.com/manuals/mfg/braun/braun_styling_iron_product_list.html