20 Most Recent Saeco Odea Go Questions & Answers

You have to 'manually' prime the pump: When the red exclamation mark shows, press the water switch on the right side (the picture of the water drip), then open up the steam nozzle and let the machine pump hot water into a cup until the red light goes out.

when the red light blinking it means machine must be primed. BUT if you prime it and still red light -you have to change the FLOWMETER.

Yes, the water pressure sensor is the most likely to have malfunctioned. You need to have that one replaced.

Oh my gawd, I have no idea what you are talking about. Dregs: Beer making?Pucks and strong shots: Hockey?Not as good as before: Well, we're all getting a bit older...

There are different possibilities for your problem. First the motor might be damaged and is more weak than before that is why is stop when it need to grind beans. In this case only with replacement motor can solve the problem. Second probably due to long use of oily coffee or low quality coffee beans or other reason there are coffee grounded in the grinder that become like rubber and does not leave the new coffee to pass through grinding burrs. For this either you have to dismantle the whole grinder and its burrs and clean them with brush or you can use a new magic product that you can fin in eBay it can clean automatically the grinder in 30 second see it at the link http://www.ebay.com/itm/PULY-GRIND-COFFEE-GRINDER-CLEANER-CRYSTALS-20-GRAMS-PACK-OF-3-PACKETS-/131031511160?ssPageName=STRK:MESE:IT You can try the above fist and you may solve the problem in minutes if not then you can proceed with the replacement of the ginder burrs or motor.

have you tried adjust coffee strenght?This is the bean symbol on the bottom of the front control

hi, when the machine is On for long time ,it going in the STAND BY MODE-green light is flashing slowly.Just press coffe button and wait for a 10 seconds. When the red light is ON and no flashing it is mean there is no water in the water tank or too much water in the drip tray.

There are multiple models that are listed as Odea Go series. Unfortunately the espresso community does not speak highly of these machines because of the low quality parts and assembly processes. The manufacturer for this unit has changed several times.

SEE THE VIODEO AND OTHER LINKS ON TYHAT SAME PAGE: ALSO: Saeco Odea Go adjusting coffee dose Questions

Did you try to put grease on the brew unit to make it movement easy?

Change the heater

Unfortunately you must sent the machine to a service. Probably the transistor that drives grinder is damaged.

Try this remove the brew unit and clean the screen, the red light is saying that it cannot push water through.

the red light for descaling you can turn off when press and hold the steam/hot water button for 5-6 seconds.