20 Most Recent Motorola Mobility H700 Headset - Page 9 Questions & Answers

how can I get copy of heath sb1400 operating and service manual

You need to start again. Turn off the speaker. On the Phone/Bluetooth click 'Forget This Device' for the speaker. Reboot the phone, and then turn on the speaker. Tell phone to search for Devices. Press the Bluetooth button on the speaker. This will correctly re-establish the pairing. https://www.fixya.com/support/r26362721-pairing_bluetooth_devices ..

I have one if you still need it.

https://www.google.com/webhp? It is a radio station especially for Ant Colonies. ANT Radio Service is a system service that was pre-installed by your device manufacturer or added as part of an Android update by your carrier and smartphone manufacturer* to allow the built-in ANT communication hardware already present in your mobile device to operate. ... See ANT+ in Mobile Devices for more info.

ANT Radio Service - THIS IS ANT

Spaminator is correct with the questions and I will add one: What coax are you using and have you tested it for shorts?

Check the capicator on the power supply which is only working on the SSB mode. Many of the 148's had a bad cap installed at the MFG. Sorry, I don't have the schematics available right now, but it is easy enough to find.

This one? https://picclick.com/6AA-Battery-Holder-for-Earlier-PRO-Series-Radio-Shack-313551499311.html https://www.google.com/search?q=realistic+pro-39+hyperscan+programmable+scanner+replacement+battery+pack ..

https://elektrotanya.com/kicker_pm500-ts_swr_meter_1974_sm.pdf/download.html

in the middle of board. towards the back there is a IC .. that is a preamp, and all the diodes for the RX and the bigger tunning transformers with the big red(sometimes) ferrites are for the RX if cannot figure it out contact me further infomatiion

I'm trying to program a Realistic Pro. 2009 and every time I hit program then the frequency and push enter it just keeps saying error can any body help me with this problem???

I held the center button for 5 seconds and it repaired by itself. I did not have to go through the resync process.

Yes it could, but... but it also depends on your antenna, what antenna are you using. Do not upgrade the power of your radio unless you know your antenna can handle the output power.

Hi,
The passcode is "0000" ...
Kay

Your laptop has a separate socket for the microphone.

unless you antenna is directional no

internal battery is dead no fix known but to replace it

Bluetooth set up https://www.google.com/search?q=2014+toyota+camry+turn+on+bluetooth ..

The max split radio for CSHF C+ is 256

It sounds like the internal battery has failed https://www.google.com/search?q=hbs-1100+tone+platinum+headset+replace+battery ..

How To Clone a BPR40 Radio
Cloning duplicates the contents of your radio (master radio) into the new radio (slave radio). Tuning and alignment information are not affected by cloning.

Set Up the Master Radio

1. Turn off the radio.
2. Press and hold Programmable Button 1 (the top programmable button) and turn on the radio. Keep pressing the Programmable Button 1 until beep is heard twice.
3. Release Programmable Button 1. Notice the LED changes to RED

Set Up the Slave Radio
1. Turn off the radio.
2. Press and hold Programmable Button 1(the top programmable button) and turn on the radio. Keep pressing Programmable Button 1 until the beep is heard three times.
3. Release Programmable Button 1. Notice that the LED changes to GREEN

BPR40 Radio to Radio Cloning Procedures
1. Connect the cloning cable to both the Master and Slave radio.
2. Press and release Programmable Button 1 of the Slave radio.
3. Within 2 seconds Press and release Programmable Button 1 of the Master radio.
4. The LED for both radios show flashing orange during cloning.
5. Once cloning is completed, an